|
SLOVENSKI STANDARD
01-junij-2021
Nadomešča:
SIST EN 60068-2-11:2001
Okoljsko preskušanje - 2-11. del: Preskusi - Preskus Ka: Slana megla (IEC 60068-2-
11:2021)
Environmental testing - Part 2-11: Tests - Test Ka: Salt mist (IEC 60068-2-11:2021)
Umgebungseinflüsse - Teil 2-11: Prüfverfahren - Prüfung Ka: Salznebe (IEC 60068-2-
11:2021)
Essais fondamentaux climatiques et de robustesse mécanique - Partie 2-11: Essais -
Essai Ka: Brouillard salin (IEC 60068-2-11:2021)
Ta slovenski standard je istoveten z: EN IEC 60068-2-11:2021
ICS:
19.040 Preskušanje v zvezi z Environmental testing
okoljem
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN IEC 60068-2-11
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2021
ICS 19.040 Supersedes EN 60068-2-11:1999 and all of its
amendments and corrigenda (if any)
English Version
Environmental testing - Part 2-11: Tests - Test Ka: Salt mist
(IEC 60068-2-11:2021)
Essais d'environnement - Partie 2-11: Essais - Essai Ka: Umgebungseinflüsse - Teil 2-11: Prüfverfahren - Prüfung
Brouillard salin Ka: Salznebell
(IEC 60068-2-11:2021) (IEC 60068-2-11:2021)
This European Standard was approved by CENELEC on 2021-04-07. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 60068-2-11:2021 E
European foreword
The text of document 104/888/FDIS, future edition 4 of IEC 60068-2-11, prepared by IEC/TC 104
"Environmental conditions, classification and methods of test" was submitted to the IEC-CENELEC
parallel vote and approved by CENELEC as EN IEC 60068-2-11:2021.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022-01-07
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2024-04-07
document have to be withdrawn
This document supersedes EN 60068-2-11:1999 and all of its amendments and corrigenda (if any).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Endorsement notice
The text of the International Standard IEC 60068-2-11:2021 was approved by CENELEC as a
European Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards
indicated:
IEC 60068-2-52 NOTE Harmonized as EN IEC 60068-2-52
ISO 8407 NOTE Harmonized as EN ISO 8407
ISO 9227 NOTE Harmonized as EN ISO 9227
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod),
the relevant EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available
here: www.cenelec.eu.
Publication Year Title EN/HD Year
IEC 60068-1 - Environmental testing - Part 1: General and EN 60068-1 -
guidance
IEC 60068-2-11
Edition 4.0 2021-03
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Environmental testing –
Part 2-11: Tests – Test Ka: Salt mist
Essais d’environnement –
Partie 2-11: Essais – Essai Ka: Brouillard salin
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 19.040 ISBN 978-2-8322-9476-5
– 2 – IEC 60068-2-11:2021 © IEC 2021
CONTENTS
FOREWORD . 3
INTRODUCTION . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 6
4 General . 6
5 Salt solution . 7
5.1 Preparation of salt solution . 7
5.2 pH adjustment . 7
5.3 Filtration . 7
5.4 Re-use . 7
6 Test apparatus . 7
6.1 Test chamber . 7
6.2 Atomizer(s) . 8
6.3 Air supply . 8
6.4 Collecting devices . 9
6.5 Method for evaluating chamber corrosivity . 9
7 Test specimens . 9
8 Initial measurements . 9
9 Pre-conditioning . 9
10 Arrangement of the test specimens . 9
11 Operating conditions . 10
12 Duration of test . 11
13 Recovery (at the end of testing) . 11
14 Final measurements . 11
15 Information to be given in the relevant specification . 11
16 Test report . 12
Annex A (informative) Examples of test apparatus for salt mist test . 13
Annex B (informative) Method for evaluating corrosivity of the apparatus . 15
B.1 General . 15
B.2 Reference specimens . 15
B.3 Arrangement of the reference specimens . 15
B.4 Duration of test . 16
B.5 Determination of mass loss (mass per area) . 16
B.6 Satisfactory performance of apparatus . 16
Bibliography . 17
Figure A.1 – Example of test apparatus for salt mist test . 13
Figure A.2 – Example of test apparatus for salt mist test . 14
Table 1 – Suggested values for the temperature of the hot water in the saturation tower . 8
Table 2 – Operating conditions . 10
IEC 60068-2-11:2021 © IEC 2021 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
ENVIRONMENTAL TESTING –
Part 2-11: Tests – Test Ka: Salt mist
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
IEC 60068-2-11 has been prep
...