|
oSIST prEN 12605:2005
01-maj-2005
Vrata v industrijske in javne prostore ter garažna vrata - Mehanske lastnosti -
Preskusne metode
Industrial, commercial and garage doors and gates - Mechanical aspects - Test methods
Tore - Mechanische Aspekte - Prüfverfahren
Portes et portails industrieles, commerciaux et de garage - Aspects mécaniques -
Méthodes d'essai
Ta slovenski standard je istoveten z: prEN 12605
ICS:
91.060.50 Vrata in okna Doors and windows
91.090 Konstrukcije zunaj stavb External structures
oSIST prEN 12605:2005 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 12605:2005
---------------------- Page: 2 ----------------------
oSIST prEN 12605:2005
EUROPEAN STANDARD
DRAFT
prEN 12605
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2005
ICS Will supersede EN 12605:2000
English version
Industrial, commercial and garage doors and gates - Mechanical
aspects - Test methods
Portes industrielles, commercial et de garage - Aspects Tore - Mechanische Aspekte - Prüfverfahren
mécaniques - Méthodes d'essais
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 33.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 12605:2005: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 12605:2005
prEN 12605:2005 (E)
Contents Page
Foreword.3
Introduction .4
1 Scope .5
2 Normative references .5
3 Terms and definitions .6
4 Test specimen.6
5 Test procedures.8
6 Contents of the test report.18
Annex A (informative) General overview of verification.19
Annex ZA (informative) Relationship between this European Document and the Essential
Requirements of EU Directive 98/37/EC .22
Bibliography .23
2
---------------------- Page: 4 ----------------------
oSIST prEN 12605:2005
prEN 12605:2005 (E)
Foreword
This document (prEN 12605:2005) has been prepared by Technical Committee CEN/TC 33 “Doors, windows,
shutters, building hardware and curtain walling”, the secretariat of which is held by AFNOR.
This document is currently submitted to the CEN Enquiry.
This document will supersed
...