|
SLOVENSKI STANDARD
01-julij-2021
Nosljive elektronske naprave in tehnologije - 201-3. del: Elektronski tekstil -
Določanje električne upornosti prevodnega tekstila v simulirani mikroklimi (IEC
63203-201-3:2021)
Wearable electronic devices and technologies - Part 201-3: Electronic textile -
Determination of electrical resistance of conductive textiles under simulated microclimate
(IEC 63203-201-3:2021)
Tragbare elektronische Geräte und Technologien - Teil 201-3: Elektronische Textilien -
Bestimmung des elektrischen Widerstandes von leitfähigen Textilien unter simuliertem
Mikroklima (IEC 63203-201-3:2021)
Technologies et dispositifs électroniques prêts-à-porter - Partie 201-3: Textile
électronique - Détermination de la résistance électrique des textiles conducteurs sous
microclimat simulé (IEC 63203-201-3:2021)
Ta slovenski standard je istoveten z: EN IEC 63203-201-3:2021
ICS:
59.080.80 Inteligentne tekstilije Smart textiles
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN IEC 63203-201-3
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2021
ICS 59.080.80
English Version
Wearable electronic devices and technologies - Part 201-3:
Electronic textile - Determination of electrical resistance of
conductive textiles under simulated microclimate
(IEC 63203-201-3:2021)
Technologies et dispositifs électroniques prêts-à-porter - Tragbare elektronische Geräte und Technologien - Teil 201-
Partie 201-3: Textile électronique - Détermination de la 3: Elektronische Textilien - Bestimmung des elektrischen
résistance électrique des textiles conducteurs sous Widerstandes von leitfähigen Textilien unter simuliertem
microclimat simulé Mikroklima
(IEC 63203-201-3:2021) (IEC 63203-201-3:2021)
This European Standard was approved by CENELEC on 2021-05-12. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 63203-201-3:2021 E
European foreword
The text of document 124/136/FDIS, future edition 1 of IEC 63203-201-3, prepared by IEC/TC 124
"Wearable electronic devices and technologies" was submitted to the IEC-CENELEC parallel vote and
approved by CENELEC as EN IEC 63203-201-3:2021.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022-02-12
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2024-05-12
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Endorsement notice
The text of the International Standard IEC 63203-201-3:2021 was approved by CENELEC as a
European Standard without any modification.
In the official version, for Bibliography, the following note has to be added for the standard indicated:
ISO 8388:1998 NOTE Harmonized as EN ISO 8388:2003 (not modified)
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod),
the relevant EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available
here: www.cenelec.eu.
Publication Year Title EN/HD Year
ISO 139 - Textiles - Standard atmospheres for EN ISO 139 -
conditioning and testing
ISO 11092 2014 Textiles - Physiological effects - Measurement EN ISO 11092 2014
of thermal and water-vapour resistance under
steady-state conditions (sweating guarded-
hotplate test)
ISO 21232 2018 Textiles - Determination of moisturizing effect - -
of textile materials by measurement of
microclimate between textiles and simulated
human skin using sweating guarded hotplate
- - Textiles and textile products - Electrically EN 16812 2016
conductive textiles - Determination of the
linear electrical resistance of conductive
tracks
IEC 63203-201-3
Edition 1.0 2021-04
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Wearable electronic devices and technologies –
Part 201-3: Electronic textile – Determination of electrical resistance of
conductive textiles under simulated microclimate
Technologies et dispositifs électroniques prêts-à-porter –
Partie 201-3: Textile électronique – Détermination de la résistance électrique
des textiles conducteurs sous microclimat simulé
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 59.080.80 ISBN 978-2-8322-9640-0
– 2 – IEC 63203-201-3:2021 IEC 2021
CONTENTS
FOREWORD . 3
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Principle of test . 6
5 Test equipment . 6
5.1 Sweating guarded-hotplate . 6
5.2 Device including temperature and humidity sensor with set-up of the four
electrode – four wire method . 6
5.3 Membranes . 7
5.4 Test enclosure of the sweating guarded-hotplate . 7
6 Test specimens . 8
6.1 Number of test specimens . 8
6.2 Dimension of specimens . 9
6.3 Conditioning . 9
7 Test procedure . 9
7.1 Preparation of textile-based electrically conductive track contact points for
necessary measurement stability . 9
7.2 Specimen mounting on measuring unit . 9
7.3 Determination of the apparatus constant R and measurement of water-
et0_al
vapour resistance including air layer R and RH) . 9
et_al
7.4 Determination of linear electrical resistance . 9
8 Test report . 10
Annex A (informative) Example of test results . 11
A.1 Sample . 11
A.2 R , RH and R . 11
et_al L
Bibliography . 13
Figure 1 – Sweating guarded-hotplate . 7
Figure 2 – Device including temperature and humidity sensor with set-up of four
electrode – four wire method . 8
Figure 3 – Example of textile-based electrically conductive track . 8
Figure A.1 – Conductive fabric . 11
Table A.1 – Arithmetic mean and CV % of test results . 12
IEC 63203-201-3:2021 IEC 2021 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
WEARABLE ELECTRONIC DEVICES AND TECHNOLOGIES –
Part 201-3: Electronic textile – Determination of electrical resistance
of conductive textiles under simulated microclimate
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international
co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and
in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports,
Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their
preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with
may participate in this preparatory work. International, governmental and non-governmental organizations liaising
with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for
Standardization (ISO) in accordance with conditions determined by agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence between
any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Att
...