|
SLOVENSKI STANDARD
01-september-2021
Integrirana vezja - Vrednotenje elektromagnetne združljivosti (EMC) oddajnikov-
sprejemnikov - 5. del: Ethernet oddajniki-sprejemniki (IEC 62228-5:2021)
Integrated circuits - EMC evaluation of transceivers - Part 5: Ethernet transceivers (IEC
62228-5:2021)
Integrierte Schaltungen - Bewertung der elektromagnetischen Verträglichkeit von Sende-
Empfangsgeräten - Teil 5: Ethernet-Sende-Empfangsgerät (IEC 62228-5:2021)
Circuits intégrés - Évaluation de la CEM des émetteurs-récepteurs - Partie 5 :
Émetteurs-récepteurs (IEC 62228-5:2021)
Ta slovenski standard je istoveten z: EN IEC 62228-5:2021
ICS:
31.200 Integrirana vezja, Integrated circuits.
mikroelektronika Microelectronics
33.100.01 Elektromagnetna združljivost Electromagnetic compatibility
na splošno in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN IEC 62228-5
NORME EUROPÉENNE
EUROPÄISCHE NORM
June 2021
ICS 31.200
English Version
Integrated circuits - EMC evaluation of transceivers - Part 5:
Ethernet transceivers
(IEC 62228-5:2021)
Circuits intégrés - Évaluation de la CEM des émetteurs- Integrierte Schaltungen - Bewertung der
récepteurs - Partie 5 : Émetteurs-récepteurs elektromagnetischen Verträglichkeit von Sende-
(IEC 62228-5:2021) Empfangsgeräten - Teil 5: Ethernet-Sende-Empfangsgerät
(IEC 62228-5:2021)
This European Standard was approved by CENELEC on 2021-05-31. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 62228-5:2021 E
European foreword
The text of document 47A/1115/FDIS, future edition 1 of IEC 62228-5, prepared by SC 47A
"Integrated circuits" of IEC/TC 47 "Semiconductor devices" was submitted to the IEC-CENELEC
parallel vote and approved by CENELEC as EN IEC 62228-5:2021.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022-02-28
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2024-05-31
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Endorsement notice
The text of the International Standard IEC 62228-5:2021 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards
indicated:
CISPR 16-1-1 NOTE Harmonized as EN IEC 55016-1-1
IEC 61000-4-2 NOTE Harmonized as EN 61000-4-2
IEC 61000-4-4 NOTE Harmonized as EN 61000-4-4
IEC 61000-4-5 NOTE Harmonized as EN 61000-4-5
IEC 61967-2 NOTE Harmonized as EN 61967-2
IEC 61967-8 NOTE Harmonized as EN 61967-8
IEC 62132-2 NOTE Harmonized as EN 62132-2
IEC 62132-8 NOTE Harmonized as EN 62132-8
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod), the
relevant EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available
here: www.cenelec.eu.
Publication Year Title EN/HD Year
IEC 61967-1 - Integrated circuits - Measurement of EN IEC 61967-1 -
electromagnetic emissions - Part 1:
General conditions and definitions
IEC 61967-4 - Integrated circuits - Measurement of EN IEC 61967-4 -
electromagnetic emissions - Part 4:
Measurement of conducted emissions - 1
ohm/150 ohm direct coupling method
IEC 62132-1 - Integrated circuits - Measurement of EN 62132-1 -
electromagnetic immunity - Part 1: General
conditions and definitions
IEC 62132-4 - Integrated circuits - Measurement of EN 62132-4 -
electromagnetic immunity 150 kHz to 1
GHz - Part 4: Direct RF power injection
method
IEC 62215-3 - Integrated circuits - Measurement of EN 62215-3 -
impulse immunity - Part 3: Non-
synchronous transient injection method
IEC 62228-1 - Integrated circuits – EMC evaluation of EN IEC 62228-1 -
transceivers – Part 1: General conditions
and definitions
ISO 10605 - Road vehicles - Test methods for electrical - -
disturbances from electrostatic discharge
ISO 21111-2 - Road vehicles - In-vehicle Ethernet - Part - -
2: Common physical entity requirements
ISO 7637-2 - Road vehicles - Electrical disturbances - -
from conduction and coupling – Part 2:
Electrical transient conduction along supply
lines only
Publication Year Title EN/HD Year
ISO/IEC/IEEE 8802-3 2017 Information technology - - -
Telecommunications and information
exchange between systems - Local and
metropolitan area networks - Specific
requirements - Part 3: Standard for
Ethernet
+A1 2017 - -
+A4 2017 - -
EIA-198-1 - Electronic Components Industry - -
Association - Ceramic Dielectric Capacitors
Classes I, II, III and IV
IEC 62228-5
Edition 1.0 2021-04
INTERNATIONAL
STANDARD
colour
inside
Integrated circuits – EMC evaluation of transceivers –
Part 5: Ethernet transceivers
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
ICS 31.200 ISBN 978-2-8322-9697-4
– 2 – IEC 62228-5:2021 © IEC 2021
CONTENTS
FOREWORD . 8
1 Scope . 10
2 Normative references . 10
3 Terms, definitions and abbreviated terms . 11
3.1 Terms and definitions . 11
3.2 Abbreviated terms . 12
4 General . 13
5 Test and operating conditions . 14
5.1 Supply and ambient conditions. 14
5.2 Test operation modes . 14
5.2.1 General . 14
5.2.2 Transceiver configuration for normal operation mode . 15
5.2.3 Transceiver configuration for low power mode . 15
5.3 Definition of BIN . 15
5.4 Test configuration . 16
5.4.1 General configuration for transceiver network . 16
5.4.2 General configuration for single transceiver . 18
5.4.3 Transceiver network tests – coupling ports and networks for conducted
tests . 18
5.4.4 Single transceiver tests – coupling ports and networks . 21
5.5 Test communication and signals . 22
5.5.1 General . 22
5.5.2 Test signals for normal operation mode . 22
5.5.3 Test signals for low power mode . 23
5.6 Evaluation criteria . 23
5.6.1 General . 23
5.6.2 Evaluation criteria for functional operation modes . 23
5.6.3 Evaluation criteria in unpowered condition after exposure to
disturbances . 24
5.6.4 Status classes . 25
5.7 DUT specific information . 26
6 Test and measurement . 26
6.1 Emission of conducted RF disturbances . 26
6.1.1 Test method . 26
6.1.2 Test setup . 26
6.1.3 Test procedure and parameters . 27
6.2 Immunity to conducted RF disturbances . 28
6.2.1 Test method . 28
6.2.2 Test setup . 28
6.2.3 Test procedure and parameters . 29
6.3 Immunity to impulses . 33
6.3.1 Test method . 33
6.3.2 Test setup . 33
6.3.3 Test procedure and parameters . 34
6.4 Electrostatic Discharge (ESD) . 36
6.4.1 Test method . 36
6.4.2 Test setup . 36
IEC 62228-5:2021 © IEC 2021 – 3 –
6.4.3 Test procedure and parameters . 41
7 Test report . 43
Annex A (normative) Ethernet test circuits . 44
A.1 General . 44
A.2 Test circuit for Ethernet transceivers for functional tests . 44
A.3 Test circuit for Ethernet transceivers for ESD test . 46
Annex B (normative) Test circuit boards. 49
B.1 Test circuit board for transceiver network configuration . 49
B.2 Test circuit board for single transceiver configuration . 51
Annex C (informative) Test of Ethernet transceiver for radiated RF emission and RF
immunity . 53
C.1 Gen
...