|
SLOVENSKI STANDARD
01-november-2019
Gospodinjski in podobni električni aparati - Varnost - 1. del: Splošne zahteve -
Dopolnilo A1
Household and similar electrical appliances - Safety - Part 1: General requirements
Sicherheit elektrischer Geräte für den Hausgebrauch und ähnliche Zwecke - Teil 1:
Allgemeine Anforderungen
Appareils électrodomestiques et analogues - Sécurité - Partie 1: Exigences générales
Ta slovenski standard je istoveten z: EN 60335-1:2012/A1:2019
ICS:
13.120 Varnost na domu Domestic safety
97.030 Električni aparati za dom na Domestic electrical
splošno appliances in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN 60335-1:2012/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
August 2019
ICS 13.120; 97.030
English Version
Household and similar electrical appliances - Safety - Part 1:
General requirements
(IEC 60335-1:2010/A1:2013 , modified + COR1:2014)
Appareils électrodomestiques et analogues - Sécurité - Sicherheit elektrischer Geräte für den Hausgebrauch und
Partie 1: Exigences générales ähnliche Zwecke - Teil 1: Allgemeine Anforderungen
(IEC 60335-1:2010/A1:2013 , modifiée + COR1:2014) (IEC 60335-1:2010/A1:2013 , modifiziert + COR1:2014)
This amendment A1 modifies the European Standard EN 60335-1:2012; it was approved by CENELEC on 2018-07-30. CENELEC
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this amendment the
status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as
the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 60335-1:2012/A1:2019 E
European foreword
This document (EN 60335-1:2012/A1:2019) consists of the text of IEC 60335-1:2010/A1:2013 +
COR:2014, prepared by IEC/TC 61 “Safety of household and similar electrical appliances”, together
with the common modifications prepared by CLC/TC 61 “Safety of household and similar electrical
appliances”.
The following dates are fixed:
• latest date by which this document has to be implemented at (dop) 2020-02-09
national level by publication of an identical national standard
or by endorsement
• latest date by which the national standards conflicting with (dow) 2021–07-30
this document have to be withdrawn
This amendment supplements or modifies the corresponding clauses of EN 60335-1:2012 and its
amendments A11:2014 and A13:2017.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a mandate given to CENELEC by the European Commission
and the European Free Trade Association, and supports essential requirements of EU Directive(s).
For the relationship with EU Directive(s) see informative Annexes ZZ.
Endorsement notice
The text of the International Standard IEC 60335-1:2010/A1:2013 + COR:2014 was approved by
CENELEC as a European Standard with agreed common modifications.
COMMON MODIFICATIONS
11 Heating
11.8 Comment to be retained in the amendment:
The deletion of the second sentence in the first paragraph was carried out in the existing common
modifications.
11.8 In Table 3 delete footnotes za, zb, zc, zd.
24 Components
Comment to be retained in the amendment: The following text replaces common modification text in
the existing standard by the IEC text including changes in A1. It also includes the paragraph from the
EN 60335-1:2012 starting by “Plugs and socket-outlets and their connecting devices….”
Replace the existing text by the following:
24.1 Components shall comply with the safety requirements specified in the relevant EN standards
as far as they reasonably apply.
Compliance with the EN standard for the relevant component does not necessarily ensure compliance
with the requirements of this standard.
Motors are not required to comply with EN 60034-1. They are tested as part of the appliance
according to this standard.
Relays shall be tested as part of the appliance according to this standard. They may be alternatively
tested to EN 60730-1, in which case they shall also meet the additional requirements in EN 60335-1.
Unless otherwise specified, the requirements of Clause 29 of this standard apply between live parts of
components and accessible parts of the appliance. Unless otherwise specified, components may
comply with the requirements for clearances and creepage distances for functional insulation as
specified in the relevant component standard.
Unless otherwise specified, the requirements of 30.2 of this standard apply to parts of non-metallic
material in components including parts of non-metallic material supporting current-carrying
connections inside components.
Components that have not been previously tested and shown to comply with the EN standard for the
relevant component are tested according to the requirements of 30.2 of this standard.
Components that have been previously tested and shown to comply with the resistance to fire
requirements in the EN standard for the relevant component need not be retested provided that
— the severity specified in the component standard is not less than the severity specified in 30.2 of
this standard, and
— unless the pre-selection alternatives in 30.2 are used, the test report for the component states the
values of t and t . as required by EN 60695-2-11.
e i
If the above two conditions are not satisfied, the component is tested as part of the appliance.
NOTE 1 There are two levels of severity specified for appliances for which 30.2.3 is applicable.
Power electronic converter circuits are not required to comply with EN 62477-1. They are tested as
part of the appliance according to this standard.
Unless components have been previously tested and found to comply with the relevant EN standard
for the number of cycles specified, they are tested in accordance with 24.1.1 to 24.1.9. For
components mentioned in 24.1.1 to 24.1.9, no additional tests specified in the relevant EN standard
for the component are necessary other than those specified in 24.1.1 to 24.1.9.
Components that have not been separately tested and found to comply with the relevant EN standard
and components that are not marked or not used in accordance with their marking, are tested in
accordance with the conditions occurring in the appliance, the number of samples being that required
by the relevant standard.
NOTE 2 For automatic controls, marking includes documentation and declaration as specified in Clause 7 of
EN 60730-1.
Lamp-holders and starter-holders that have not been previously tested and found to comply with the
relevant EN standard are tested as a part of the appliance and shall additionally comply with the
gauging and interchangeability requirements of the relevant EN standard under the conditions
occurring in the appliance. Where the relevant EN standard specifies these gauging and
interchangeability requirements at elevated temperatures, the temperatures measured during the tests
of Clause 11 are used.
There are no additional tests specified for nationally standardized plugs such as those detailed in
IEC/TR 60083 or connectors complying with the standard sheets of EN 60320-1 and EN 60309,
unless they are specifically mentioned in the text of this standard.
Plugs and socket-outlets and other connecting devices of interconnection cords shall not be
interchangeable with plugs and socket-outlets listed in IEC/TR 60083 or IEC 60906-1 or with
connectors and appliance inlets complying with the standard sheets of EN 60320-1, if direct supply to
these parts from the supply mains could give rise to a hazard.
When an EN standard does not exist for a component, there are no additional tests specified.
Annex ZC
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 When an International Publication has been modified by common modifications, indicated by
(mod), the relevant EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is
available here: www.cenelec.eu.
Replace the reference to IEC 60252-1 with the following:
Publication Year Title EN/HD Year
IEC 60252-1 2010 AC motor capacitors - Part 1: General - EN 60252-1 2011
Performance, testing and rating - Safety
requirements - Guidance for installation
and operation
Add the following references:
Publication Year Title EN/HD Year
IEC 60034-1 (mod) - Rotating electrical machines -- Part 1:
EN 60034-1 2010
Rating and performance
IEC 60730-2-9 2008 Automatic electrical controls for household EN 60730-2-9 2010
(mod) and similar use - Part 2-9: Particular
requirements for temperature sensing
controls
IEC 61558-2-16 - Safety of transformers, reactors, power EN 61558-2-16 2009
supply units and similar products for supply
voltages up to 1 100 V - Part 2-16:
Particular requirements and tests for switch
mode power supply units and transformers
for switch mode power supply units
+ A1 2013
IEC 62477-1 - Safety requirements for power electronic EN 62477-1 2012
converter systems and equipment - Part 1:
General
+ A11 2014
+ A1 2017
Bibliography
The following note has to be added for the standard indicated:
IEC 60068-2 NOTE Harmonized as EN 60068-2
IEC 60335-1
Edition 5.0 2013-12
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
AMENDMENT 1
AMENDEMENT 1
Household and similar electrical appliances – Safety –
Part 1: General requirements
Appareils électrodomestiques et analogues – Sécurité –
Partie 1: Exigences générales
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
CODE PRIX S
ICS 13.120, 97.030 ISBN 978-2-8322-1203-5
– 2 – 60335-1 Amend. 1 © IEC:2013
FOREWORD
This amendment has been prepared by IEC technical committee 61: Safety of household and
similar electrical appliances.
The text of this amendment is based on the following documents:
FDIS Report on voting
61/4639/FDIS 61/4675/RVD
Full information on the voting for the approval of this amendment can be found in the report
on voting indicated in the above table.
The committee has decided that the contents of this amendment and the base publication will
remain unchanged until the stability date indicated on the IEC web site under
"http://webstore.iec.ch" in the data related to the specific publication. At this date, the
publication will be
reconfirmed,
withdrawn,
replaced by a revised edition, or
amended.
The contents of the corrigendum of January 2014 have been included in this copy.
NOTE The attention of National Committees is drawn to the fact that equipment manufacturers and testing
organizations may need a transitional period following publication of a new, amended or revised IEC publication in
which to make products in accordance with the new requirements and to equip themselves for conducting new or
revised tests.
It is the recommendation of the committee that the content of this publication be adopted for implementation
nationally not earlier than 12 months or later than 36 months from the date of publication.
_____________
1 Scope
Add the following to Note 1:
Dual supply appliances, either mains-supplied or battery-operated, are regarded as battery-operated appliances
when operated in the battery mode.
60335-1 Amend. 1 © IEC:2013 – 3 –
2 Normative references
Replace the reference to IEC 60252-1 by the following:
IEC 60252-1:2010, AC motor capacitors – Part 1: General – Performance, testing and rating –
Safety requirements – Guidance for installation and operation
Add the following references:
IEC 60034-1, Rotating electrical machines – Part 1: Rating and performance
IEC 60730-2-9:2008 , Automatic electrical controls for
...