|
SLOVENSKI STANDARD
01-december-2018
3UHVNXãDQMH]PRJOMLYRVWLLQHQHUJLMVNHXþLQNRYLWRVWLIRWRQDSHWRVWQHJD 39
PRGXODGHO (QHUJLMVNDXþLQNRYLWRVWIRWRQDSHWRVWQHJD 39 PRGXOD
Photovoltaic (PV) module performance testing and energy rating - Part 3: Energy rating
of PV modules
Prüfung des Leistungsverhaltens von photovoltaischen (PV)-Modulen und
Energiebemessung - Teil 3: Energiebemessung von PV-Modulen
Essais de performance et caractéristiques assignées d'énergie des modules
photovoltaïques (PV) - Partie 3: Caractéristiques assignées d’énergie des modules PV
Ta slovenski standard je istoveten z: EN IEC 61853-3:2018
ICS:
27.015 (QHUJLMVNDXþLQNRYLWRVW Energy efficiency. Energy
2KUDQMDQMHHQHUJLMHQD conservation in general
VSORãQR
27.160 6RQþQDHQHUJLMD Solar energy engineering
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN IEC 61853-3
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2018
ICS 27.160
English Version
Photovoltaic (PV) module performance testing and energy rating
- Part 3: Energy rating of PV modules
(IEC 61853-3:2018)
Essais de performance et caractéristiques assignées Prüfung des Leistungsverhaltens von photovoltaischen
d'énergie des modules photovoltaïques (PV) - Partie 3: (PV)-Modulen und Energiebemessung - Teil 3:
Caractéristiques assignées d'énergie des modules PV Energiebemessung von PV-Modulen
(IEC 61853-3:2018) (IEC 61853-3:2018)
This European Standard was approved by CENELEC on 2018-10-04. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden,
Switzerland, Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2018 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 61853-3:2018 E
European foreword
The text of document 82/1441/FDIS, future edition 1 of IEC 61853-3, prepared by IEC/TC 82 "Solar
photovoltaic energy systems" was submitted to the IEC-CENELEC parallel vote and approved by
CENELEC as EN IEC 61853-3:2018.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2019-07-04
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2021-10-04
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Endorsement notice
The text of the International Standard IEC 61853-3:2018 was approved by CENELEC as a European
Standard without any modification.
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod), the relevant
EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available here:
www.cenelec.eu.
Publication Year Title EN/HD Year
IEC 60891 - Photovoltaic devices - Procedures for EN 60891 -
temperature and irradiance corrections to
measured I-V characteristics
IEC 60904-3 - Photovoltaic devices - Part 3: EN 60904-3 -
Measurement principles for terrestrial
photovoltaic (PV) solar devices with
reference spectral irradiance data
IEC 60904-7 - Photovoltaic devices - Part 7: Computation EN 60904-7 -
of the spectral mismatch correction for
measurements of photovoltaic devices
IEC 60904-8 - Photovoltaic devices - Part 8: EN 60904-8 -
Measurement of spectral responsivity of a
photovoltaic (PV) device
IEC 60904-8-1 - Photovoltaic devices - Part 8-1: EN 60904-8-1 -
Measurement of spectral responsivity of
multi-junction photovoltaic (PV) devices
IEC 61853-1 - Photovoltaic (PV) module performance EN 61853-1 -
testing and energy rating - Part 1:
Irradiance and temperature performance
measurements and power rating
IEC 61853-2 - Photovoltaic (PV) module performance EN 61853-2 -
testing and energy rating - Part 2: Spectral
responsivity, incidence angle and module
operating temperature measurements
IEC 61853-4 - Photovoltaic (PV) module performance - -
testing and energy rating – Part 4:
Standard reference climatic profiles
IEC/TS 61836 - Solar photovoltaic energy systems - - -
Terms, definitions and symbols
IEC 61853-3
Edition 1.0 2018-08
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Photovoltaic (PV) module performance testing and energy rating –
Part 3: Energy rating of PV modules
Essais de performance et caractéristiques assignées d'énergie des modules
photovoltaïques (PV) –
Partie 3: Caractéristiques assignées d’énergie des modules PV
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 27.160 ISBN 978-2-8322-5989-4
– 2 – IEC 61853-3:2018 © IEC 2018
CONTENTS
FOREWORD . 3
INTRODUCTION . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 7
4 Testing . 7
5 Report . 7
6 Module energy collection . 8
6.1 General . 8
6.2 Input module data for energy rating . 8
6.3 Input standard reference climatic profiles . 9
7 Procedure for energy rating . 9
7.1 General . 9
7.2 In-plane global irradiance corrected for angular incidence effects . 10
7.3 Spectrally corrected global in-plane irradiance . 11
7.4 Calculation of module temperature . 12
7.5 Determination of instantaneous module power . 12
7.6 Calculation of hourly module energy output . 13
7.7 Calculation of annual module energy output . 13
7.8 Climatic specific energy rating . 13
Figure 1 – Flow chart of calculation procedure . 10
IEC 61853-3:2018 © IEC 2018 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
PHOTOVOLTAIC (PV) MODULE PERFORMANCE
TESTING AND ENERGY RATING –
Part 3: Energy rating of PV modules
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and
non-governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates
closely with the International Organization for Standardization (ISO) in accordance with conditions determined
by agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
International Standard IEC 61853-3 has been prepared by IEC technical committee 82: Solar
photovoltaic energy systems.
The text of this International Standard is based on the following documents:
FDIS Report on voting
82/1441/FDIS 82/1451/RVD
Full information on the voting for the approval of this International Standard can be found in
the report on voting indicated in the above table.
This document has been drafted in accordance with the ISO/IEC Directives, Part 2.
– 4 – IEC 61853-3:2018 © IEC 2018
A list of all parts in the IEC 61853, published under the general title Photovoltaic (PV) module
performance testing and energy rating, can be found on the IEC website.
The committee has decided that the contents of this document will remain unchanged until the
stability date indicated on the IEC website under "http://webstore.iec.ch" in the data related to
the specific document. At this date, the document will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
...