|
SLOVENSKI STANDARD
01-december-2021
Določevanje posameznih snovi v elektrotehničnih izdelkih - 3-3. del: Preséjanje
polibromiranih bifenilov, polibromiranih difenil etrov in ftalatov v polimerih s
pirolizo (Py-GC-MS) ali s termodesorpcijsko plinsko kromatografijo z masno
spektrometrijo (TD-GC-MS)
Determination of certain substances in electrotechnical products Part 3-3: Screening of
polybrominated biphenyls, polybrominated diphenyl ethers and phthalates in polymers by
pyrolysis (Py-GC-MS) or thermal desorption (TD-GC-MS) gas chromatography-mass
spectrometry
Ta slovenski standard je istoveten z: EN IEC 62321-3-3:2021
ICS:
29.020 Elektrotehnika na splošno Electrical engineering in
general
31.020 Elektronske komponente na Electronic components in
splošno general
71.040.50 Fizikalnokemijske analitske Physicochemical methods of
metode analysis
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN IEC 62321-3-3
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2021
ICS 13.020.01; 43.040.10
English Version
Determination of certain substances in electrotechnical products
- Part 3-3: Screening - Polybrominated biphenyls,
polybrominated diphenyl ethers and phthalates in polymers by
gas chromatography-mass spectrometry using a
pyrolyser/thermal desorption accessory (Py/TD-GC-MS)
(IEC 62321-3-3:2021)
Détermination de certaines substances dans les produits Verfahren zur Bestimmung von bestimmten Substanzen in
électrotechniques - Partie 3-3: Détection - Diphényles Produkten der Elektrotechnik - Teil 3-3: Screening der
polybromés, diphényléthers polybromés et phtalates dans polybromierten Biphenyle, polybromierten Diphenylether
les polymères par chromatographie en phase gazeuse- und Phthalate in Polymeren durch Pyrolyse (Py-GC-MS)
spectrométrie de masse par pyrolyse/thermodésorption oder Thermodesorption-Gaschromatographie-
(Py/TD-GC-MS) Massenspektrometrie (TD-GC-MS)
(IEC 62321-3-3:2021) (IEC 62321-3-3:2021)
This European Standard was approved by CENELEC on 19 October 2021. CEN and CENELEC members are bound to comply with the
CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard
without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CEN and CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN and CENELEC member into its own language and notified to the CEN-CENELEC Management Centre
has the same status as the official versions.
CEN and CENELEC members are the national standards bodies and national electrotechnical committees of Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain,
Sweden, Switzerland, Turkey and United Kingdom
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 All rights of exploitation in any form and by any means reserved worldwide for CEN national Members and for
CEN/CENELEC CENELEC Members.
Ref. No. EN IEC 62321-3-3:2021 E
European foreword
The text of document 111/626/FDIS, future edition 1 of IEC 62321-3-3, prepared by IEC/TC 111
“Environmental standardization for electrical and electronic products and systems” was submitted to
the IEC-CENELEC parallel vote and approved by CENELEC as EN IEC 62321-3-3:2021.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022–07–19
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2024–10–19
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 62321-3-3:2021 was approved by CENELEC as a
European Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards
indicated:
IEC 62321-1:2013 NOTE Harmonized as EN 62321-1:2013 (not modified)
IEC 62321-2:2013 NOTE Harmonized as EN 62321-2:2014 (not modified)
IEC 62321-8:2017 NOTE Harmonized as EN 62321-8:2017 (not modified)
IEC 62321-3-1:2013 NOTE Harmonized as EN 62321-3-1:2014 (not modified)
IEC 62321-3-2:2020 NOTE Harmonized as EN IEC 62321-3-2:2020 (not modified)
2 3
IEC 62321:2008 NOTE Harmonized as EN 62321:2009 (not modified)
ISO 3696 NOTE Harmonized as EN ISO 3696
ISO/IEC 17025 NOTE Harmonized as EN ISO/IEC 17025
To be published. Stage at time of publication: prEN IEC 62321-3-2:2020.
Withdrawn.
Withdrawn.
IEC 62321-3-3
Edition 1.0 2021-09
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
HORIZONTAL PUBLICATION
PUBLICATION HORIZONTALE
Determination of certain substances in electrotechnical products –
Part 3-3: Screening – Polybrominated biphenyls, polybrominated diphenyl ethers
and phthalates in polymers by gas chromatography-mass spectrometry using a
pyrolyser/thermal desorption accessory (Py/TD‑GC‑MS)
Détermination de certaines substances dans les produits électrotechniques –
Partie 3-3: Détection – Diphényles polybromés, diphényléthers polybromés et
phtalates dans les polymères par chromatographie en phase gazeuse-
spectrométrie de masse par pyrolyse/thermodésorption (Py/TD‑GC‑MS)
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 13.020.01; 43.040.10 ISBN 978-2-8322-1011-6
– 2 – IEC 62321-3-3:2021 © IEC 2021
CONTENTS
FOREWORD . 4
INTRODUCTION . 6
1 Scope . 7
2 Normative references . 7
3 Terms, definitions and abbreviated terms . 7
3.1 Terms and definitions . 7
3.2 Abbreviated terms . 9
4 Principle . 10
4.1 Overview. 10
4.2 Principle of test . 11
5 Reagents and materials . 11
6 Apparatus . 12
7 Sampling . 12
8 Procedure . 12
8.1 General instructions for the analysis . 12
8.2 Sample preparation . 13
8.2.1 General . 13
8.2.2 Polymer sample . 13
8.2.3 Stock solution or polymer reference material . 13
8.3 Instrumental parameters . 13
8.4 Calibration . 15
8.4.1 General . 15
8.4.2 Determination of RRFs . 15
9 Calculation of PBBs, PBDEs and phthalates concentration . 16
9.1 General . 16
9.2 Determination of RF of DEHP . 17
9.3 Calculation . 17
9.3.1 Calculation of RF . 17
9.3.2 Calculation of concentration. 17
10 Precision . 18
10.1 Screening judgement . 18
10.2 Repeatability and reproducibility . 20
11 Quality assurance and control . 23
11.1 General . 23
11.2 Quality control . 23
11.2.1 Sensitivity test . 23
11.2.2 Blank test . 23
11.2.3 System stability test . 24
11.2.4 Degradation test . 24
11.2.5 RRF test . 24
11.3 Method detection limit (MDL) and limit of quantification (LOQ) . 25
12 Test report . 25
Annex A (informative) Flow chart of screening and verification test method . 26
Annex B (informative) Principle of Py/TD-GC-MS instruments . 28
Annex C (informative) Other test methods . 29
IEC 62321-3-3:2021 © IEC 2021 – 3 –
Annex D (informative) Commercially available reference solutions and materials . 30
D.1 Reference solution . 30
D.2 Polymer reference materials . 31
Annex E (informative) Sampling procedure . 33
E.1 Sample preparation using cutting tools. 33
E.2 Sample preparation using cryogenic grinding mill . 33
E.3 Accurate weighing of sample . 33
E.4 Method of sample injection . 33
Annex F (informative) Verification of the EGA thermal desorption zone . 34
Annex G (informative) Example of chromatograms . 36
Annex H (informative) Examples of RRFs . 37
Annex I (informative) Sample analysis sequence . 38
Annex J (informative) Results of international inter-laboratory study 3-3 . 39
Bibliography . 42
Figure A.1 – Flow chart for screening step and verification test step for PBDEs, PBBs
and phthalates .
...