|
SLOVENSKI STANDARD
01-februar-2022
Nadomešča:
SIST EN 60335-2-96:2003
SIST EN 60335-2-96:2003/A1:2004
SIST EN 60335-2-96:2003/A2:2009
Gospodinjski in podobni električni aparati - Varnost - 2-96. del: Posebne zahteve
za grelne elemente z zvijavimi ploščami za sobno gretje
Household and similar electrical appliances - Safety - Part 2-96: Particular requirements
for flexible sheet heating elements for room heating
Ta slovenski standard je istoveten z: EN IEC 60335-2-96:2021
ICS:
13.120 Varnost na domu Domestic safety
97.100.10 Električni grelniki Electric heaters
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN IEC 60335-2-96
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2021
ICS 97.100.10; 13.120 Supersedes EN 60335-2-96:2002 and all of its
amendments and corrigenda (if any)
English Version
Household and similar electrical appliances - Safety - Part 2-96:
Particular requirements for flexible sheet heating elements for
room heating
(IEC 60335-2-96:2019)
Appareils électrodomestiques et analogues - Sécurité - Sicherheit elektrischer Geräte für den Hausgebrauch und
Partie 2-96: Exigences et particulières pour les films ähnliche Zwecke - Teil 2-96: Besondere Anforderungen an
souples chauffants pour le chauffage des locaux Flächenheizelemente
(IEC 60335-2-96:2019) (IEC 60335-2-96:2019)
This European Standard was approved by CENELEC on 2021-09-20. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 60335-2-96:2021 E
European foreword
This document EN IEC 60335-2-96:2021 consists of the text of IEC 60335-2-96:2019 prepared by
IEC/TC 61 "Safety of household and similar electrical appliances".
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022-09-20
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2024-09-20
document have to be withdrawn
This document supersedes EN 60335-2-96:2002 and all of its amendments and corrigenda (if any).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
This document is read in conjunction with EN IEC 60335-2-96:2021/A11:2021.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
For relationship with EU Directive(s) / Regulation(s), see informative Annex ZZA, which is an integral
part of EN IEC 60335-2-96:2021/A11:2021.
Endorsement notice
The text of the International Standard IEC 60335-2-96:2019 was approved by CENELEC as a
European Standard.
IEC 60335-2-96
Edition 2.0 2019-05
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Household and similar electrical appliances – Safety –
Part 2-96: Particular requirements for flexible sheet heating elements for room
heating
Appareils électrodomestiques et analogues – Sécurité –
Partie 2-96: Exigences particulières pour les films souples chauffants pour le
chauffage des locaux
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 97.100.10; 13.120 ISBN 978-2-8322-6865-0
– 2 – IEC 60335-2-96:2019 © IEC 2019
CONTENTS
FOREWORD . 4
INTRODUCTION . 7
1 Scope . 8
2 Normative references . 8
3 Terms and definitions . 9
4 General requirement . 10
5 General conditions for the tests . 10
6 Classification . 11
7 Marking and instructions . 11
8 Protection against access to live parts . 16
9 Starting of motor-operated appliances . 16
10 Power input and current . 16
11 Heating . 17
12 Void . 21
13 Leakage current and electric strength at operating temperature . 21
14 Transient overvoltages . 21
15 Moisture resistance . 22
16 Leakage current and electric strength . 22
17 Overload protection of transformers and associated circuits . 23
18 Endurance . 23
19 Abnormal operation . 25
20 Stability and mechanical hazards . 26
21 Mechanical strength . 26
22 Construction . 28
23 Internal wiring . 30
24 Components . 30
25 Supply connection and external flexible cords . 30
26 Terminals for external conductors . 31
27 Provision for earthing . 31
28 Screws and connections . 31
29 Clearances, creepage distances and solid insulation . 31
30 Resistance to heat and fire . 32
31 Resistance to rusting . 32
32 Radiation, toxicity and similar hazards . 32
Annexes . 46
Annex AA (informative) Summary of installation instructions . 47
Bibliography . 49
Figure 101 – Arrangement for testing heating units in timber ceilings . 33
Figure 102 – Arrangement for testing modular heating units . 34
Figure 103 – Arrangement for testing heating units in timber floors . 35
IEC 60335-2-96:2019 © IEC 2019 – 3 –
Figure 104 – Arrangement for testing heating units below concrete . 36
Figure 105 – Arrangement for testing heating units in timber floors and ceilings in
combination . 37
Figure 106 – Jig for locating the contact needle . 38
Figure 107 – Arrangement for testing heating units above timber floors . 39
Figure 108 – Arrangement for testing heating units above concrete floors . 40
Figure 109 – Arrangement for measuring capacitive currents . 41
Figure 110 – Arrangement for testing heating units in timber walls . 42
Figure 111 – Arrangement for testing heating units in both sides of timber wall
applications . 43
Figure 112 – Arrangement for testing heating units intended to be installed in a wall of
concrete or similar material . 44
Figure 113 – Arrangement for testing heating units against wall of concrete or similar
material . 45
Table 101 – Temperature rise limits for surfaces . 21
Table AA.1 – Summary of installation instructions . 47
– 4 – IEC 60335-2-96:2019 © IEC 2019
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
HOUSEHOLD AND SIMILAR ELECTRICAL APPLIANCES – SAFETY –
Part 2-96: Particular requirements for flexible
sheet heating elements for room heating
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the m
...