First, you need a generator motor. If you are making a miniature wind turbine, a four-wheel drive motor can be used instead. Then you place the wings you made on the front rotor head of the engine. is used to provoke wind. When the wind turns the motor rotor, both ends of the wire at the rear end of the motor can produce electricity. This is the energy production principle of the wind turbine, but this method can only produce electricity and. is not practical.
Secondly, if you need a really practical micro wind turbine, you need to do the following steps and prepare some materials, such as diode and voltage regulator (voltage stabilizing circuit board) , a battery. , etc.
When you prepare these materials, you can first connect one end of the generator motor wire to a diode to prevent powerThis generated flow back to the motor, then connect it to the voltage regulator (a reminder here) The voltage stabilizing power of the voltage stabilizer should be determined in advance, and it should meet the parameter requirements of the generated voltage by the motor to prevent the voltage stabilizer circuit board from burning) before connecting the battery to the voltage stabilizer (the battery voltage should also be stable. (within the rated parameters of the voltage regulator) and you have finished. When the wind turns your motor, the electricity generated will be processed by the voltage stabilization circuit and stored in the battery~
The largest wind turbine The wind blades are 80 meters long. The largest wind turbine in the world is located in Maade, Denmark. It is called V164 and was manufactured and installed by Mitsubishi Vestas Offshore Wind Company. This wind turbine is 220 meters high and equipped.ed by three giant blades. Each blade is 80 meters long, which is longer than a Boeing 747.