A van hit a wind turbine blade, how did it hit it?

We don't know how the collision happened. The accident in question is still under investigation, so we can only wait for further investigation results to confirm the cause of the collision!

According to online media, a serious traffic accident occurred at a traffic light intersection in Bucheng County, Shaoyang City, Province of Hunan. It turned out that a van hit an A. The truck was carrying wind blades, and the wind blades were directly inserted inside the van, causing a serious traffic accident that killed a person and injured one.

According to information collected, the truck carrying wind turbine blades stopped at a traffic light intersection.

Since the wind blades are so huge, even if a large truck is used to transport them, the size of the bladesThe wind blows far beyond the body of the vehicle.

At that time, a van was coming from the opposite direction. When the van on the opposite side turned left and entered the intersection, for some unknown reason, it suddenly hit this huge blade of wind. force of the wind The blades passed directly through the window of the minivan, directly causing the tragedy of one death and one injury.

Some netizens claimed that the van hit the wind blades. It may be that when the van was turning left at the intersection, it was in a blind spot and did not see the blades before hitting it.

Of course, some netizens think it's because the truck lowered the tail of the wind blade too low. If the tail of the wind blade does not go very low, then it is impossible for the van to do so. turn around. Contact with wind blades.

Of course, there is currently no confirmed explanation as to why the van hit the wind blades. Additionally, there were no reports of anyone breaking any traffic laws during this incident. It should therefore not be a case of a traffic violation.

But we must also take this as a warning. We must pay attention to road conditions when we set off, and for the sake of our own safety, we must also obey the traffic laws.

What do you think? Welcome to leave a message for discussion.

The production method is as follows:

1 Buy a generator with a power of 200 W and a rated speed of about 400 rpm

2. You can use some ABS pipes to cut blades and then polish them properly after cutting as shown below:

3. Find a metal disk to connect thee generator and the blades, that is. the hub in the generator. ;

4. Drill holes in the blades and metal discs. Pay attention to the best time to drill holes when drilling, for example:

5. You can find a hub cover for the wheel hub to prevent the screws from being exposed to wind and sun, but they can also play a diversion role;

6. Make a stand for the generator, just wood, then use wire or iron sheets to secure the generator;

7. Make a connecting rod, preferably fitted with a bearing, then make a tower with water pipes, so that the wires connecting the generator can be installed;This hole is drilled; Finally, the tower and the generator are connected and fixed with guyed steel cables to complete the production.