Dual Power Wind Turbine Cabin Installation Steps:
1. Clean the surface of the cabin cover before lifting.
2. Install the cabin cover upper arc cover plate onto the cabin cover.
3. Insert the wind speed and direction meter installation accessories into the mounting holes of the wind measuring mast mounting frame in order, and insert the wind speed and direction meter cable at the same time time.
4. The ultrasonic wind speed and direction meter is installed and fixed.
5. Install the aviation light, slowly move the crane according to the tower installer's instructions, and use bolts and washers to connect the tower to the cabin.
6. Install the upper part of the cabin ladder on the machine base, connect it with bolts and flat washers and tighten it with a wrench.
Thiscannot be achieved.
If wind turbines can be installed on electric vehicles to achieve good results, then many electric vehicle manufacturers have already done so. If wind energy is used to generate electricity, the voltage is unstable. but it is difficult to implement.
In the past, many manufacturers even considered relying on solar power generation, but the investment was too large and the cost of factory-produced electric vehicles was too high, they did not have therefore not been realized.
Detailed information:
Principle of the wind turbine:
It is an electrical machine that converts wind energy into mechanical work, also known as windmill. It is a thermal energy engine that uses the sun as the heat source and the atmosphere as the working fluid. Wind energy uses energynatural energy. Wind power is not considered a backup energy source, but it can be used long term.
The principle of wind power generation is to use wind energy to rotate the blades of the wind turbine, and then use a speed multiplier to increase the rotation speed to encourage the generator to produce electricity.
Wind energy is gaining popularity around the world because it poses no fuel problems and does not produce radiation or air pollution.
The small wind power generation system is very efficient, but it is not composed of a single generator head, but a small system with certain technological content: wind turbine + charger + digital inverter. The wind turbine consists of a nose, a rotor, a tail and blades.
Each part is very important, and the functions of each part are: The blades are used pto receive the force of the wind and convert it into electrical energy through the nose; the tail allows the blades to always face the direction of; the wind ; the pivot allows the nose to rotate flexibly; the rotor of the machine head is a permanent magnet and the stator winding cuts the magnetic lines of force to generate electrical energy.
As the wind volume of the wind turbine is unstable, it must be rectified by the charger, and then the battery is charged, so that the electrical energy generated by the wind turbine is converted into chemical energy. Then use an inverter with a protection circuit to convert the chemical energy of the battery into AC 220V mains power to ensure stable use.
Mechanical connection and power transmission The horizontal axis fan blades are connected to the universal elastic coupling through the gearbox and its high-speed shaft, and transmit torque to the shafte generator drive. The other type is the direct drive type of fan motor where the blades are directly connected to the motor without passing through the gearbox.
Reference documents:
Baidu BaiduBranch - wind turbine