How to use the wind rope buckle:
When using it, insert the non-sliding end of the wind rope into the buttonhole of the tent, tie it tightly, then start to adjust the sliding end of the wind rope, so that the slider and the wind rope buckle can be fixed.
1. Step 1: Remove the ring rope near the end of the rope in the sliding piece and cover the nails with soil. No matter what type of tent stake you use, use it to tighten it down.
2. Step 2: Select the location of the floor nails based on the soil conditions. Generally speaking, the smaller the angle between the windproof rope and the ground, the better the wind resistance of the tent. Insert the floor nails into the ground at a 45 to 60 degree angle to maximize stress.
3. Step 3: Tighten the front end of the windproof rope with one hand, hold the tthree-hole oboggan with the other hand and push it closer to the end of the tent. Tighten firmly, the tighter the better.
4. Step 4: Release your hands. If the entire tent rope is still very tight, it means that the windproof rope is installed. If you notice any play, simply follow the method above and continue to tighten it.
Follow the four steps above to use the wind rope loop correctly. The main purpose of the wind rope loop is to properly insulate the inside and outside of the tent. Only when done well can the wind rope buckle play its role.
Depending on the shape of the tent selected, one end of the windproof rope is generally tied to the tent, and the other end is nailed to the ground with ground nails and tightened in four directions to prevent the tent from being blown away by the wind. At the same time, use nailsol to secure the four corners to the ground. Some floor nails are not easy to insert and must be hit with something. This can easily damage the floor nails. easy place to insert.