Since the size of the wind changes at any time, the output voltage of the generator changes between 13 and 25 and then is rectified. More precisely, there may be a rectifier circuit such as a chopper circuit. be stable. , charging the battery to convert the electrical energy generated by the wind turbine into chemical energy is deliberately misleading. Just like you usually charge a dry battery, electrical energy is converted into chemical energy and then into multiple batteries with just 12 volts. (general batteries are 12V) Increase the output capacity by connecting in parallel and increase the output voltage by connecting in series (just like the series and parallel connection of dry batteries. The so-called mains power supply is usable electricity, it does not have any). special meaning
If you want to use five. Whether the electricity generated by the device is stored in a battery depends firstthe storage voltage of your battery and whether the input and output mode is DC or AC, and whether the output of your generator is DC or AC.
If your device is 24v with five devices connected in series, it will be 120 volts You can connect diodes in series to the two wires in front of the battery (also called a bridge rectifier, which is not necessary if the battery input is AC), then charge the battery with a storage voltage of 110 (80 to 115 is suitable. If the storage voltage is too low, the battery will be burned, and if the storage voltage is too low, the battery will be burned. is too high, it will not be charged). If connected in parallel, the voltage is 24v. You can charge batteries below 24v. You must always connect the diode opposite. The current rating of the unit is approximately 4.17 amps. If the parallel voltage is equal, the current will be added, and if the series current is equal, the voltage will be added. Five units of one wellRated power of 100 watts is equivalent to 500 watts, which means that under standard conditions each unit can generate 100 watts of electricity per hour. In fact, it's usually not much unless you're in a windy place. very loud and blows constantly.
If you want to convert it to 220V, there are voltage transformer modules available on the market, or you can use two 110V batteries in series. Generally, home appliances use AC power. If your battery has DC output and the transformer module does not convert DC to AC, it can only be used for pure resistance appliances such as incandescent lamps, rice cookers, electric cookers, etc. use an inverter to convert it to AC power. Which electrical devices can be charged depends on your battery output current and device currents electrics. Generally, the current of electrical appliances is 0.8 times the output current of the battery, and the current of electrical appliances can. be only lower and not higher than the battery output current. Also look at the battery capacity, which should be greater than the maximum battery run time multiplied by the generator power. For example, if you change the battery once a day, the battery capacity should be 24*100, or 2.4 kilowatt hours. The capacity of the battery converted to 24 V is one hundred amp hours. Additionally, the battery input current must be greater than the unit output current.