The generator belt and the air conditioner belt are not the same on the 17 JAC Refeng S3. The generator belt is used to drive the generator to produce electricity, while the air conditioning belt is used to operate the air conditioning compressor. They have obvious differences in function and use.
Alternator belts are typically longer and wider than air conditioner belts because the generator must produce more power. Additionally, the generator belt is usually connected to the engine crankshaft wheel so that the rotation of the engine drives the generator. The air conditioning belt is usually connected to the air conditioning compressor to drive the air conditioning system throughout the rotation of the engine.
It should be noted that different models and engine configurations may vary. By coTherefore, in specific cases, it is recommended to consult the vehicle manual or consult a professional auto repair technician to ensure you choose the right one. . belt. In addition, regular inspection and replacement of belts are also important steps to maintain normal vehicle operation and avoid breakdowns caused by aging or damage of belts.
Extended content: In addition to generators and air conditioning systems, modern cars usually have other drive systems, such as water pump drive belts, drive belts power steering pump, etc. Each drive system has its own specific belts to ensure the proper functioning of each component. Therefore, when purchasing and replacing belts, choose according to the specific needs of the drive system and effPerform regular maintenance and replacement to ensure vehicle reliability and safety.
Think back to the times
Regarding the situation you mentioned, one possibility is that the generator belt slipped or the generator itself failed, this which made the generator's energy production too low. while the vehicle is driving, the power generated cannot reach the power required for normal operation of the vehicle. At this time, battery power will be consumed, causing the vehicle to fail to start after a period of driving. time. Another possibility is that the vehicle circuit itself has iron or power-consuming parts. Therefore, turning on the ignition switch will consume a large amount of battery power, causing the vehicle to fail to start after driving for a period of time. Then you can check these dthem aspects. Both of these conditions can be measured with a multimeter. It is estimated that the store maintenance staff may find it inconvenient and do not want to check.
See more information about [JAC Ruifeng]: http://www.webcars.com.cn/jac-ruifeng/