The fuel consumption of JAC Ruifeng diesel car is about 10 liters per 100 kilometers
I have already driven this car for more than 400,000 kilometers
I sense that the power of this car is very good
The high speed can reach 140 kilometers
The failure rate is also low
Just a reminder of refill oil at ordinary gas stations< /p>
When you feel that the power is insufficient
< p>Then the high pressure pump filter must be a little dirty< /p>It needs to be cleaned over time
I have been driving my Ruifeng car for half a year. Battery died this morning and failed to start?
There may be more than one. Reasons why JAC Refeng S2 is not powered on the whole car:
1. The whole car is not getting power, it's probably because the battery is running out of power. Check if the battery. the power supply is weak andrecharge the battery to restore it.
2. The power of various electrical equipment in the car is too large, which affects the circuit and damages the battery. It can also cause the entire car to lose power.
3. The car's generator breaks down. The main power system comes from the battery and generator. Once the generator fails, power transmission will be impossible.
4. The car's fuse is blown, which will cause the entire car to lose power.
How to install the belt of JAC Ruifeng 1.9t diesel version
1. The generator is broken (this rarely happens, please replace the generator or repair the generator).
2. The generator regulator is broken (Ruifeng is prone to this common problem, so replace the regulator).
3. The power generation output terminal has poor contact (very rare, clean the dirt et tighten the terminals).
4. The battery does not store electricity (It may happen that after the generator regulator fails, the generated voltage is high and the battery is burned out. Inspection method: 1) Check if the battery water is cloudy. If it is cloudy, it means it is burnt. Be sure to repair the generator and replace the regulator. Otherwise, the new battery will burn out. 2) Use a meter to measure the power generation voltage. If the idle speed is less than 13.8 V and the full throttle speed is more than 14.8 V, there is a problem with the governor.)
5. The belt is loose and the power generation is not enough (this is easy to happen, especially for Ruifeng diesel, just loosen the tight belt. If it is a diesel engine, carefully check whether the connection hole between the generator and the engine is worn and if it is loose, repair it in time.)
1. First of all, there is a parabolic tooth groove on the JAC Ruifeng 1.9t diesel generator. Loosen the nut on it.
2. Second, use a crowbar to move the generator away from the engine, then tighten the nut. There is no need to loosen the nut and just use a wrench to tighten the nut directly.
3. Finally, install the belt.