Two reasons: One: Check if the generator's power output is between 13 and 14. Two: The battery starting voltage is too low, about 10 volts is normal. If it doesn't reach the level, the battery is failing internally. damaged! Replacement Hope this helps. If you have a problem with your car, ask an auto guru. Professional technicians at 4S stores can solve the problem within 10 minutes. 3022
How to install the LoFon compressor belt
To adjust the tightness of the Chevrolet LoFon generator belt, you must first loosen the belt tensioner screw, then use the adjustment screw or tensioner Tighten the adjustment lever to adjust the tightness of the belt. Specific adjustment methods vary depending on the car and engine model, so it is best to consult the vehicle's instruction manual or consult a professional technician.el to determine the correct adjustment method and sequence. Normally, you need to use proper tools to loosen the tension pulley screws, then adjust the screws or tension adjustment rod to make the belt achieve the proper tightness. Once the adjustment is complete, you should recheck the belt tightness and tensioner pulley position to ensure the adjustment is correct and the screws are secure. It is recommended to check the vehicle belt for wear and tension regularly, and adjust or replace it in time to avoid malfunctions and safety problems.
Can be installed by yourself. From the information of LeFeng compressor belt, we learned that LeFeng compressor belt can be installed by yourself. The installation steps are as follows:
1. First, align the mark on the rear timing gearcamber with the mark on the valve cover and install the timing belt in sequence.
2. Second, loosen the pulley and install the bolt 1/4 to 1/2 turn. Compress the automatic tensioner push rod to the lowest position and insert the steel needle into the hole. Use circlip pliers to adjust the pulley. Turn counterclockwise to make the two pulley adjustment holes parallel to the ground. . Remove the steel needle and turn it clockwise. Turn the crankshaft 2 times and check that the timing marks are correctly aligned.
3. Finally, return to the engine, lower the timing belt cover with your right fingernail and cover the outer timing belt cover. Reinstall the generator and A/C compressor belts and check for any. any abnormality in the engine.