Steps to make your own small wind turbine using PVC pipes:
First you need a generator motor. If you are making a miniature wind turbine, a four-wheel drive motor can be used. used instead. Place the prepared wings on the front rotor head of the motor to cause wind. When the wind turns the motor rotor, both ends of the wire at the rear end of the motor can generate electricity. wind turbine, but this can only produce electricity and is not practical.
Secondly, if you need a really practical micro wind turbine, you need to do the following steps and prepare some materials, like diode and voltage regulator (voltage stabilizing circuit board), a battery, etc.
When preparing these materials, you can first connect one end of the generator motor wire to a diode to prevent powere generated to flow back to the motor, and then connect it to the voltage regulator (which must remember here that the voltage stabilizing power of the voltage stabilizer must first be determined, and it must meet the parameter requirements of the voltage generated by the motor to prevent the voltage stabilizer circuit board from burning), then connect the battery to the voltage stabilizer (the battery voltage should also be within the rated parameters of the voltage regulator) and you are finished. When the wind turns the motor, the electricity generated will be processed by the voltage stabilization circuit and stored in the. battery.