1. The extinguisher switch is not activatedand the extinguisher wire is shorted. Lack of automatic oil protection.
2. Sensor: Disconnect the oil sensor cable and replace the oil sensor if the gasoline engine can start.
3. Ignition system problems:Disconnect the spark plug and start the engine without loading, and observe the spark if it is white and red, replace it. no spark, replace spark plug or igniter.
4. Fuel systemproblems: Check to see if water has entered the fuel. If water has entered, clean the carburetor with gasoline. To determine if fuel has entered the cylinder, disconnect the spark plug and press the air filter hole firmly with your finger. Pull it to start several times and smell the fuel with your finger. DeterminedCheck if there is an air leak in the oil supply channel and change the position of the shock absorber to see if it can start.
Precautions for gasoline generators
Please note that the generator should be installed in a place out of reach of passers-by and children.
Never place flammable objects near the exhaust vent when the generator is running.
The distance between this generator and buildings or other devices should be kept at least 1 meter. Otherwise, the generator will overheat. Do not cover the dust cover while the generator is running.
Why do gasoline generators often stall automatically during operation?
Generators are usually composed of stators, rotors, covers, etc. end, bearings and other components.
The stator consists of the stator core, wire windings, machine base andt other structural parts that secure these parts.
The rotor is composed of a rotor core winding (or magnetic pole, magnetic yoke), retaining ring, center ring, slip ring, a fan and a rotating shaft.
There are many types of generators. In terms of energy, they are divided into thermal generators, hydraulic generators, etc. ; In principle, they are divided into synchronous generators, asynchronous generators, single-phase generators and three-phase generators. In terms of generation method, they are divided into steam turbine generators, hydraulic generators, diesel generators, gasoline generators, etc.
The working principle is that the stator and rotor of the generator are connected and assembled by the bearings and end covers, so that the rotor can rotate in the stator and carry out the cutting movement magnetic lines of force., thus generating an induced electrical potential, which crosses the terminals. When removed and connected in the loop, a current is generated.
Gasoline generators often stall automatically during operation. There are several reasons. One is lack of oil, the other is the oil circuit blocked, the third is the body temperature is too high. and the fourth is The load is too great. These situations will cause the gasoline generator to automatically stall during operation.
If the machine is not very old or old, it is recommended to replace the spark plug and carburetor. If it is certain that the spark plug is not the fault, it is recommended that the oil supply line is not slick and cleaned or replaced.
Detailed information:
In case of prolonged non-use, How to store the gengasoline erators:
1. Empty all gasoline from the fuel tank and carburetor
2. Drain all oil from the crankcase;
3. Add new engine oil to the upper limit of the oil level on the oil dipstick;
4. Close the choke and pull the starter handle to where resistance is felt;
< p> 5. Wipe the appliance clean and cover it with a cardboard or plastic cover to avoid dust.