A common problem with the JAC Ruifeng 19t diesel version is that the generator voltage is unstable and can be replaced at a 4S store. The JAC Ruifeng 19t diesel version is an MPV from JAC Motors. The engine has a maximum power of 139 horsepower and a maximum torque of 285 Nm. It comes with a 6-speed manual transmission. The length, width and height of the JAC Ruifeng 19t diesel version are 5,090 mm, 1,820 mm and 1,970 mm respectively, with a wheelbase of 3,080 mm and a top speed of 160 kilometers per hour. The fuel tank capacity of this car is 80L. The front suspension is double wishbone independent suspension, the rear suspension is leaf spring non-independent suspension, and the driving mode is front and rear wheel drive.
Refeng S2 generator belt installation method
I'm not from Baoding, so I don't need to go to a store4S to repair it, it's too expensive.
For a service at an auto repair shop in Heilongjiang, 5,000 yuan is enough and everything can be replaced. (Timing belt, all belts, valve grinding, pump calibration 200 yuan, bushing replacement, circuit). It is estimated that the price will not be much different. The maintenance costs and accessories of refined diesel are expensive.
The connection between the generator and the body should be carefully checked (all Ruifeng diesels have this problem). If it is loose, it must be replaced or aluminum welded. This part is so damaged that the generator may fall down in severe cases. I had this problem with my car.
How to install the belt of JAC Ruifeng 1.9t diesel version
1. First loosen the generator fixing screw and the belt tightness adjustment screw.
2. Second, place the Ruifeng generator2 against the engine so that the distance between the pulleys is the shortest, then place the belt sleeve on the rocker hammer.
3. Finally, adjust the belt tightness to the appropriate level, tighten the motor mounting screws and adjust the screws.
1. First of all, there is a parabolic tooth groove on the JAC Ruifeng 1.9t diesel generator. Loosen the nut on it.
2. Second, use a crowbar to move the generator away from the engine, then tighten the nut. There is no need to loosen the nut and just use a wrench to tighten the nut directly.
3. Finally, install the belt.