1. Check for antifreeze in the generator water tank, diesel in the oil drum, and generator oil.
2. Check if the generator battery switch is closed, if the speed switch is in the low speed position, if the power switch behind the generator is closed, and if the generator power switch is electricity the transformer in the room is closed.
3. During a power outage, convert the internal and external lines of the main transformer to generate electricity:
1. Turn on the generator battery switch.
2. Turn the generator start knob to start the generator. After waiting for the generator to start normally, Kejian Construction Machinery recommends adjusting the low speed gear to the high speed gear and paying attention to the generator starting normally. the voltage of the generator is 380 volts.
3. When the voltage stabilizes at 380 volts, turn on the generator, then turn on the power switch.
Fourth, after completing the above three steps, turn the power switch of the transformer in the power generation room to supplement the power supply to the west hospital area.
You can chat with me privately ~ Under normal circumstances, we will take care of the equipment when using it, but if the range extender generator accidentally receives water water due to poor maintenance, what should we do? To ensure normal operation of the equipment? 1. Do not start the range extender generator immediately after water has entered it. Rinse the surface of the diesel engine with water, remove dirt and debris, then clean the oil stains on the surface. . 2. Support one end of the generatoreur so that the oil drain portion of the engine oil pan is in the lowest position. Unscrew the oil drain plug and remove the oil dipstick to allow the water in the oil pan to drain out on its own. . 3. Remove the intake and exhaust pipes and muffler, and remove the internal water. Turn on the pressure relief and crank the engine to see if water flows from the inlet and exhaust ports. If there is water drained, continue to rotate the crankshaft until all the water in the cylinder is drained. 4. Remove the air filter, remove the upper filter shell, remove the filter element and other components, remove the water from the filter and clean all parts. After drying, install it in accordance with regulations. 5. Remove the fuel tank, drain all the oil and water, and check for water in the filter and oil pipe. If there is water, drain it. Cleanthe fuel tank and diesel filter, then put them back in place, connect the oil line and add clean fuel to the fuel tank. 6. Remove the generator, check the stator and rotor inside the generator, then dry them before reassembly. @2019