How to drain the water tank of the diesel generator. Generator manufacturers believe that because the external ambient temperature is too low, the cooling water should be discharged after 15 minutes of shutdown when the water temperature has dropped, not immediately, otherwise the temperature difference between the fuselage and the external environment will be too important. , causing the diesel generator to fail. Some parts of the unit are deformed, which in turn affects the performance of the diesel engine (such as cylinder head deformation, etc.). When the cooling water stops flowing, it is best to shake the diesel generator several times. At that time, the remaining cooling water that does not flow easily will flow out due to the vibration of the diesel engine. can prevent the water on the cylinder head from freezing. If it falls, cooling water will flow into the engine oil pan. The operator must also notter that if the water drain switch is not removed, the water drain switch must be in the open state after water draining is completed to avoid cooling water The remaining water cannot temporarily flow for various reasons and freezes. the corresponding parts of the diesel engine. Generator manufacturers remind users not to activate the water release switch and everything will be fine when releasing the water. They also need to pay attention to the specific water flow conditions to see if the water flow is steady and whether it is getting smaller. or faster and slower. If these conditions occur, it means that the cooling water contains impurities that hinder the normal flow of water. At this point, it is best to remove the water drain switch and let the cooling water flow directly from the body. If the water flow is still not regular, uUse hard, thin steel objects such as wire to dredge it until the water flow is steady.
The diesel generator water tank is leaking and cannot be used. The water tank of the diesel generator set is an important accessory of the water-cooled engine. As an important component of the heat dissipation circuit of the water-cooled engine, it can evaporate the heat energy of the cylinder and prevent the engine from overheating. . When it is found that there is a small amount of cracks and leaks in the inlet and outlet pipes of the water tank, you can wrap the leak tightly with tape or a cloth coated with soap , then tie it tightly with a thin wire, wrap it outside with tape, then tie it tightly with a thin wire. This is a very common treatment method. During processing, plastic pipes of the same diameter are used, whichcan also be used temporarily to replace damaged rubber hoses.