The specific operation method for removing scale in the water tank of the diesel generator is as follows: first use 30 kg of water, 2.5 kg of caustic soda and 0.6 kg of kerosene to prepare a cleaning solution and pour it into the water tank. Then start the diesel engine and run it at medium speed for about 10 minutes, then stop it. Wait 10 to 12 hours before restarting the diesel engine, run it at medium speed for about 10 minutes, stop the engine and release the cleaning fluid. After adding clean cooling water, start the diesel engine and run it at medium speed to clean itself. Repeat this operation 2 to 3 times to completely remove the tartar.
Should the water in the water tank of the diesel generator be added before or after starting? Is there any difference?
Anthracene, this water tank does not need to be changedafter a single use. It can be changed after running for a while, for example around February. As long as there is water in the water tank during operation and the machine is not burned out, you will be fine. If it is a generator, it can run continuously because it has many generators that can produce electricity in turn. If it is a single machine, it should run for a while and let the machine rest and cool down. To avoid burning the cylinder and piston! !
Can the diesel generator water tank still be used if it leaks?
The diesel generator water tank is an important part of the water cooled engine . Water-cooled engine cooling system, it can absorb heat from the cylinder block to prevent diesel engine from overheating. However, when using, users should pay attentionn to the fact that the water tank of the generator set cannot be without cooling water or add it after start-up.
If cooling water is added after the diesel generator set is started, important components such as hot cylinder liner and cylinder head will explode or deform due to sudden combustion and cold. Similarly, if boiling water at 100°C is suddenly added to a cold body, the cylinder head will crack and the body will break.
Yatong reminds everyone that the correct operation method of the diesel generator water tank is: before starting the diesel generator, cooling water should be added first and hot water of about 60℃ should be added to the diesel engine. preheat it before starting.
The diesel generator water tank is leaking and cannot be used. The water tank of the diesel generator set is an acimportant accessory of the water-cooled engine. As an important component of the heat dissipation circuit of the water-cooled engine, it can evaporate the heat energy of the cylinder and prevent the engine from overheating. . When it is found that there is a small amount of cracks and leaks in the inlet and outlet pipes of the water tank, you can wrap the leak tightly with tape or a cloth coated with soap , then tie it tightly with a thin wire, wrap it outside with tape, then tie it tightly with a thin wire. This is a very common treatment method. During processing, plastic pipes of the same diameter are used, which can also be used temporarily to replace damaged rubber pipes.