No. Do not flush the engine directly when washing the car. Once the motor contacts water, if it is not wiped in time, it will cause various components to short circuit or open circuit, or damage various components, seriously affecting operation. of the engine. If the engine is flushed with high temperature water, the oil seal will leak. Once the cylinder bursts, the engine will need to be replaced directly.
Avoid rinsing with water when the car is hot. The reason for this is to prevent the cylinder from warping and cracking when the engine is cold at high temperatures. Be careful to avoid opening the external fuse box to avoid letting water enter the engine, which could cause the car's drive computer to short circuit and prevent it from starting. The engine compartment after washing is not completely dry and there are still a few droplets of water remainingu. Over time, electrical interfaces will oxidize, resulting in poor conduction and component damage.
Detailed information:
1. The longer salt, dust, insects, bird droppings and other debris stick to the car, the more destructive they will be to the car, so it should be cleaned in time. .
2. When rinsing the car with water, be careful not to spray water into the keyhole.
3. If the car is sent to the auto cleaning equipment for cleaning, there is no need to remove the antenna if the car is equipped with a roof antenna.
4. The vehicle body is stained with asphalt, oil stains, industrial dirt or insects, etc. If left too long, they can damage the paint. The spots pcan be removed using asphalt strippers, insect eliminators, etc.
5. When cleaning the body paint surface, do not use brushes, coarse cloths, etc. to avoid leaving scratches.
6. When cleaning, use scattered jets of water to soak hard dust and mud and be impacted, then scrub up and down with a sponge. Finally, wipe off the water stains with deerskin.
7. When cleaning the engine room, be careful not to splash water on the distributor, ignition coil and other parts of the electrical system. Otherwise, the engine will have difficulty starting. If water splashes on the electrical parts, wipe them with a dry cloth or blow them with compressed air and remove the moisture from the dispenser cover.
8. After washing the car or driving in deep water, the braking effect may be reduced because thebrake parts are hardened. You should brake lightly to judge the braking effect. If the brakes are abnormal, you should brake while driving at low speed for a while to dry the brakes.
Reference materials:
It is not easy for water to enter the generator. You need to be careful when you have to wash the engine. Do not wash the generator if water gets into it, do not start the engine for half an hour. The battery has nothing to do with it. The engine is also It can be flushed. The engine is basically sealed and the air filter has a cover. So it doesn't matter.