It is located at the bottom of the water tank. You can find it by carefully observing the bottom of the water tank. According to the diagram, the part near the front of the car is filled with glass water and the part near the car window is filled with antifreeze.
The first step is to stop the car engine to avoid injury.
The second step is to turn off the car engine, find the hood switch on the side of the cab door and pull it to open it.
The third step is to open the front hood and find the car battery in the engine room.
The fourth step is to disconnect the negative cable from the car battery to avoid electric shock during installation.
Step 5: With the battery off, remove the plastic cover from the outside of the belt on the side of the motor as shown below.
Step 6 : After removing the plastic cover, remove the generator assembly.
Step 7: After removing the motor assembly, you will find a water pipe underneath, remove it.
Step 8: Since there is water in the water pipe, the antifreeze will spurt out after removing the sewer pipe. Please be careful not to burn yourself.
Ninth step, then wait until the water drains out and you can clearly see the thermostat directly, which means all the water in the water tank has been released.
Notes:
Daily maintenance of car water tanks:
1. The radiator must not be corroded by acids or alkalis. or other contact of a sexual nature.
2. It is recommended to use soft water. Hard water should be softened before use to prevent clogging and scaling inside the radiator.
3. When using antifreeze, to avoid corrosion ofu radiator, be sure to use long-lasting anti-rust antifreeze produced by regular manufacturers and meeting national standards.
4. When installing the radiator, please do not damage the heat sink (sheet) or bruise the radiator to ensure heat dissipation capacity and waterproofness.
5. When completely draining and filling the radiator, first turn on the engine block water drain switch. When the water drains, close it again to avoid blisters.