The diesel engine runs the generator, converting diesel energy into electrical energy.
In the cylinder of the diesel engine, the clean air filtered by the air filter is fully mixed with the high pressure atomized diesel fuel injected by the injector. Under the upward pressure of the piston, the volume decreases and the volume decreases. the temperature rises rapidly, reaching the ignition point of diesel.
The diesel ignites, the gas mixture burns violently, and the volume increases rapidly, pushing the piston down, which is called "work".
Notes:
1. The fuel supply and return areas of the fuel tank shall be equipped with perforated bulkheads to reduce heat exchange from the diesel generator set; The return pipe is bad. This causes shock waves in the fuel in the oil lines of the diesel generator.
2. The location of the storeStorage of the fuel tank must be safe to avoid fires. The fuel tank or oil barrel should be placed alone in a visible place, far enough away from the diesel generator, and smoking is prohibited. strictly prohibited.
3. After the fuel tank is placed, the maximum oil level cannot be 2.5 meters higher than the base of the diesel generator set.
4. The oil port resistance should not exceed the specified value when using a clean filter element specified in the performance data sheet of all diesel generator sets. This resistance value is based on the fuel tank containing half the fuel; the connection of the fuel return line should not cause shock waves in the fuel in the oil line of the diesel generator set; the fuel capacity in the fuel tank must ensure a supplydaily operation.
5. The end of the fuel supply pipe of the fuel tank should be approximately 50mm higher than the bottom of the diesel generator tank to prevent sediment and water from being drawn into the fuel supply pipe.
Detailed information:
Factory generator structure:
< p > Generators are generally composed of stators, rotors, end covers, bearings and other components. The stator consists of the stator core, wire windings, machine base and other structural parts that secure these parts.The rotor is composed of a rotor core winding (or magnetic pole, magnetic yoke), retaining ring, center ring, slip ring, a fan and a rotating shaft.
The stator and rotor of the generator are connected and assembled by the bearings andend covers, so that the rotor can rotate in the stator and perform the cutting motion of the magnetic lines of force, thus generating an induced effect. electric potential, which is discharged through the terminals and connected to the circuit, an electric current is generated.
Reference source: Baidu Encyclopedia Generator