Absolutely, but it should be noted that the power of the generator itself is the same or similar. In addition, their voltage frequency must be consistent, and the phase must be consistent, especially the frequency is absolutely the same, otherwise it. will not work and the generator may even be short-circuited.
p>This requires parallel cabinets, which can greatly improve the stability of voltage and current. If the voltage is not enough, you can work on the current. generator to increase the voltage. The voltage and frequency of the two machines must be consistent
The hydrogenerator synchronization device reports a disconnection and the voltage is too low to connect to the grid
No.
1. After the small horizontal hydraulic generator is connected to the grid, the frequency of the generator is 50Hz. The normal fluctuation range should not exceed 5%, and it will not trigger.
2. THEThe power factor of a small horizontal grid-connected hydrogenerator changes all the time, so the power factor also changes. A dynamic compensation cabinet is used to achieve power factor compensation, as well as power. the factor is 1. When the total line current is at least 0.8, it will not trip in the range of 0.8.
The hydrogenerator synchronization device signals a disconnection and the voltage is too low to be connected to the network. The solution is to check the fault and eliminate it in time. When connected to the grid, if the generator voltage and frequency are not higher than the system, the generator will be used as a load by the grid and consume power instead. Just like when charging a cell phone, if the charger voltage used is too low, the charging time will be long or it will not charge. InSome cases, the more you charge, the phone will consume power faster than usual, resulting in faster power consumption than usual. means the charger becomes a charge for fun.