Water bag for watering the groundNeedle eyeWater leak solution: Once the water belt has holes, cut it the old water belt that was used before and use it. a soldering iron to solder the old agricultural water bag. On new agricultural water belts, cut the water bag under the old water belt to be larger than the area where the copper water belt was broken.
Buy relatively high quality glue to use on agricultural water bags. Remember to buy good agricultural water belts, otherwise some problems will occur; the leak point is at the joint. seal and retie it if necessary, or use a piece of old agricultural pipe to tie it around the leak.
How to use water pipes
1. The use of braided hoses should comply with the quality standards of the hose itself and try to avoidprevent the hose from being exposed to high pressure beyond its own pressure range.
2. After using the woven hose, clean it, hang the liner hose to dry, then store it in a cool, dry place.
3. If a small hole is found in the hose during use, wrap the hose well and weave it or repair it as soon as possible after obvious damage appears, replace it immediately.
4. Try to avoid kinks and dead bends in the pipe during use, and try to reduce the pressure on the pipe during work.
5. When installing water belts, if you have to pass the railway tracks, you must go under the railway tracks to avoid unnecessary risk of car accidents.
Choosing a high quality pipe will make the operation more efficient and avoid water leaks and burst pipes in the pouring area. For example, a pipe that uses a filamentt of high-strength polyester, the raw material of the car seat. belts, in the form of a braided line. It has strong pressure resistance and wear resistance, and there will be no pipe bursting or leaking during normal operation of floor pouring.