1. Discharge the hot water from the solar water heater.
2. Carefully remove the dust seal ring on top of the header tube. If it is very dirty, rinse the top with lukewarm water.
3. Remove the black collection tube. Wear rubber gloves to avoid slipping and bruising. Grasp it with both hands and twist it left and right with a little force. Once it can be rotated, apply upward force to let the heat collecting tube enter part of the water tank, then lift the bottom and gently remove it. . Pay attention to the sealed glass mouth at the bottom to prevent it from being damaged and losing its vacuum insulation function.
4. Pour the water into the collection tube and pour out the scale at the same time. Remove one, shake it lightly, and pour it in while it's still hot. Then pour water with a spoon, shake and rinse several times juntil it is clean.
5. Remove the rubber sealing ring inside the water tank mouth. After removing them all, rinse them with water, especially on the inside, to ensure a good seal with the collection tube.
6. Clean the scale from the water tank. Use a curved tool to remove large areas of tartar, then rinse with plenty of water.
7. Install the rubber seal ring. Use your hands to facilitate installation from the two holes and place it on the stainless steel edge of the water tank. After installing the collection tube, prepare a little detergent diluent, rinse the top of the collection tube with water, apply a little detergent solution and slowly push the top into the water tank. Be careful not to damage the lower vacuum glass nozzle.
8. Add water to test if there is a water leak. Fill with water and checkcheck for water leaks. It is recommended to empty the first water tank to remove remaining detergent. If there is no water leakage, just press the dust ring.
1. Drain the hot water from the solar water heater.
2. Carefully remove the dust seal ring on top of the header tube. If it is very dirty, rinse the top with lukewarm water.
3. Remove the black collection tube. Wear rubber gloves to avoid slipping and bruising. Grasp it with both hands and twist it left and right with a little force. Once it can be rotated, apply upward force to let the heat collecting tube enter part of the water tank, then lift the bottom and gently remove it. . Pay attention to the sealed glass mouth at the bottom to prevent it from being damaged and losing its vacuum insulation function.
4. Pour the water into the neck tubereader and pour out the scale at the same time. Remove one, shake it lightly, and pour it in while it's still hot. Then pour water with a spoon, shake and rinse several times until clean.
5. Remove the rubber sealing ring inside the water tank mouth. After removing them all, rinse them with water, especially on the inside, to ensure a good seal with the collection tube.
6. Clean the scale from the water tank. Use a curved tool to remove large areas of tartar, then rinse with plenty of water.
7. Install the rubber seal ring. Use your hands to facilitate installation from the two holes and place it on the stainless steel edge of the water tank. After installing the collection tube, prepare a little detergent diluent, rinse the top of the collection tube with water, apply a little detergent solution and push slowlytop into the water tank. Be careful not to damage the lower vacuum glass nozzle.
8. Add water to test if there is a water leak. Fill with water and check for leaks. Draining the water is recommended. A container of water to drain any remaining dish soap. If there is no water leakage, just press the dust ring.