Before disassembling the vacuum glass tube of the solar water heater, you must first take down the dust-proof ring (O-type rubber ring) near the water tank. You can apply a little water before moving it, which will make it. It is easier to move the dust ring down, then hold the vacuum tube with both hands and push it up clockwise when the small tail at the end of the vacuum tube exposes the exhaust pipe (the metal bracket at the bottom of the vacuum tube). holds the vacuum tube), slightly lift the lower part of the vacuum tube to the top of the exhaust pipe, then grip the vacuum tube counterclockwise and pull it down. if he touches this place, he will flee. If you disassemble and clean the vacuum tube, remember to replace the white silicone ring in the water tank, otherwise it will leak after reinserting it.
CombHow much does high-rise solar dismantling cost in Hefei?
The dismantling and assembly of solar water heaters requires certain skills and precautions. Here are the general steps for disassembly and assembly of solar water heaters:
Disassembly of solar water heaters:
Turn off the water heater: First of all, make sure that the hot water supply to the solar water heater is turned off. You can close the valve connected to the water heater or turn off the power to the water heater.
Drain the water heater: Open the water heater drain valve and completely drain the water from the water heater. This step aims to reduce weight during disassembly and prevent water leaks.
Disconnect the water pipe: Use a wrench or other suitable tool to gently loosen the connection between the solar water heater and the water pipe. This usually includes the inlet and outlet pipes.
Unplug the power source (the(if applicable): If the solar water heater is operating on an electrical source, make sure the power is turned off and the electrical connection is disconnected.
Remove the mounting bolts: Check the mounting bolts or brackets of the solar water heater, use suitable tools to loosen and remove them.
Lift the water heater carefully: Lift the solar water heater carefully to ensure that it is not damaged or bumped during transportation.
Installing a solar water heater:
Prepare the installation location: Choose a suitable location to install the solar water heater and ensure that the support or the fixture is firm and reliable.
Install the fixing bolts: According to the design and requirements of the solar water heater, install the fixing bolts or brackets in the predetermined position.
Connect the water pipes: connect the tuyau water inlet pipe and the water outlet pipe, making sure the connection is tight and well sealed. Use appropriate sealing materials, such as pipe sealing tape or pipe putty, if necessary.
Connect to a power source (if applicable): If your solar water heater requires a power source, make sure it is properly connected and perform all safety checks. necessary security.
Water Filling: Open the water inlet valve and inject water into the solar water heater system. Make sure the water is circulating properly and check for leaks.
The cost of disassembly and assembly of solar panels for high-altitude operations in Hefei is about 300 yuan.
If personnel are more than 5 meters and less than 10 meters from the building floor, 15% of labor costs will be charged.
If the height of the operational objectis 10 meters from the ground, it can be climbed. If it is less than 20 meters, 20% labor costs will be charged.