Solar energy is an environmentally friendly and energy efficient hot water solution. However, during use, valve leaks of solar water heaters may occur due to aging parts and excessive water pressure. What can we do about it?
First of all, when a leak is detected in the valve of the solar water heater, the valve should be closed immediately and the water heater should be dismantled and cleaned to check whether the valve is worn , if there has. stuck debris, etc. For worn valves, it is necessary to replace new parts and check whether the seal ring is intact; For valves stuck by debris, it is necessary to clean them to return them to normal service, and at the same time replace the sealing rings to ensure a waterproof effect. Additionally, if the solar water heater is used for a long time, water leakage may occur due toaging of the seal ring. At this point, the sealing ring should be replaced with a new one.
In addition, in order to prevent similar problems from occurring again, when using solar water heaters, you should regularly check whether the valve components are normal in order to avoid the wear and blockage of the valve under high temperature and pressure conditions. At the same time, when maintaining solar water heaters, attention should be paid to the use of original accessories to ensure the quality of sealing rings, valves and other components, and to avoid leaks caused by the use of inferior accessories.
In short, solar valve leaks should be dealt with in time, and at the same time, strengthened maintenance and upkeep can effectively prevent similar problems from occurring again.
In this case, the chances of replacing himer without breaking the wall are very weak. The solenoid valve is connected to the water line below the mixer and to the water line above the mixer. valve, simply use a spanner to unscrew it. When folding it, please note that you must first empty all the water from the water tank, then close the main water inlet valve before use.
The upper exhaust is leaking. When the solar power is filled with water, the normal situation is that the water will overflow and leak first if the water supply valve is not closed in time. due to the rapid flow of water, overflow will occur slowly, excess water will be discharged from the upper exhaust, which is normal.
If the upper exhaust pipe is emptied first, you can pull the overflow pipe down 1-2 cm, or lift the upper exhaust pipe up by approximately 1 cm. The bucket lid is leaking. En general, the bucket lid does not leak. If it leaks, the silicone ring of the vacuum tube may be broken. Water flows into the bucket lid along the foaming material and flows out of the bucket lid. .