Use bent pliers to remove the sealing ring. Water leaks are usually caused by excessive scale buildup.
If it is a better and new seal ring, you can buy it online according to the size of the seal ring, then use a tweezers to carefully install it in place, then slowly push the Water Pipe Joint, rotate it while pushing, or apply a little soap or dish soap to make installation easier. Solar energy is a renewable energy source. It refers to the radiant thermal energy of the sun (see the three modes of propagation of thermal energy: radiation), and its main manifestation is often called solar rays. Nowadays, it is typically used to generate electricity or provide energy for water heaters.
Technical principle
EnergySolar energy is generated by the fusion of hydrogen and helium inside the sun to release enormous nuclear energy. sun. Most of the energy needed by humans comes directly or indirectly from the sun. Plants release oxygen, absorb carbon dioxide and convert solar energy into chemical energy and store it in the plant body through photosynthesis.
Fossil fuels such as coal, oil and natural gas are also primary energy sources formed by the evolution of ancient plants and animals buried underground over a long geological period. The energy contained in the earth itself generally refers to the energy related to the thermal energy inside the earth and the energy related to the nuclear reaction.
1. Turn off the water supply and remove the faucet handle.
2. Unscrew the packing nut and remove the sealing ringyou.
3. Install a new seal ring. If linear sealant is used, wrap it around the valve core several times. If it is a leather pad, just put it on directly.
3. Insert the silicone ring into the insulating bucket. Hold the silicone ring and look at the edge. There is a groove in the middle of the silicone ring. On both sides of the groove, one side should be. be thicker and the outer circle larger. The outer circle should be thinner and smaller. The side with the thinner side and smaller outer circle faces inward when placed at the water tank suction pipe hole. The groove should be completely closed with the stainless steel hole visible at the mouth of the water tank suction pipe.
4. Repeat steps on the top surface of each tube. Next comes intubation. During intubation, wetz first the windshield (usually a black rubber ring between the vacuum tube and the outer wall of the water tank) with clean water and place it on the open upper end of the vacuum tube . ?
5. Use laundry detergent to moisten the installed silicone ring, or add water to the solar panel to let the water flow out of the vacuum tube hole.
6. Hold the tail of the vacuum tube with one hand to protect the end of the tail, and hold 1/3 of the vacuum tube with the other hand. Use uniform force and keep the direction of the force consistent with the direction. Coaxial line of the tube mouth. Insert the vacuum tube into the water tank. At this point you can insert an additional section into the vacuum tube hole. Once the tail of the vacuum tube is aligned with the protective bracket, pull it out. until the vacuum tube and the protective bracket are firmly fixed, then place the retaining ring firmlywindshield against the exterior wall of the water tank.