The bottom of the tank is on the far left.
Usually, the magnesium rod is installed on the far left of the bottom of the water heater tank. Some water heaters need to remove the plastic base underneath to view the drain nut.
Siji Muge's business scope includes heat pumps, solar energy, water purification equipment technology development, technology transfer and technical training; the sale of electric heaters and accessories, solar water heaters and accessories; solar power generation equipment and accessories, electric water heaters, mechanical equipment, building materials, metal materials, kitchen appliances, water purification equipment, air purification equipment, air conditioning equipment, equipment heat pump.
What to do if the magnesium rod of the solar water heater is leaking
M6mm×diameter 20mm×length 300mm? SunRain is the global leader in solar thermal energy utilization and a professional technology and service provider for the composite utilization of solar thermal energy and air energy. The general model of magnesium rods of its solar water heaters measures M6mm × 20mm in diameter × 300mm in length. Solar water heaters are divided into structural forms. These are vacuum tube solar water heaters and flat panel solar water heaters, mainly vacuum tube solar water heaters.
1. It is more common that the silicone seal ring used during installation has been damaged or deformed due to aging, resulting in poor sealing. This type of solar water heater magnesium rod is likely to occur. a water leak problem. 2. There is also a problem of water leakage in the connection port and in thewater tank itself, which can easily cause the magnesium rod of the split solar water heater to leak during use. 3. Sometimes due to the rupture of the inner tank, water leakage will occur if there is no way to use it normally.
Suggested solutions: 1. Determine if the leak is caused by aging of the silicone seal ring. If the degree of deformation is serious, it is generally recommended to replace the silicone seal ring with a new one. so that it can be restored to its previous state. Sealing can avoid the water leakage problem of magnesium rod when reused. 2. First check whether the connection port and the water tank itself are leaking. If the water tank itself is leaking, it is recommended to replace and repair it in time. After repair, the problem of leakage of the magnesium rod of the solar water heater. will be resolved. 3. Sometimes the resinner glass breaks due to neglect. In this case, it is not recommended to continue using it. It should be replaced and repaired in time under the intervention of professionals to completely solve the leakage problem.