It is not illegal to install a Pacific Automotive Network roof rack. To install a roof rack, you must register with the vehicle management office before you can install it. Roof racks are not illegal, but it should be noted that the height of a passenger car's luggage rack from the roof should not exceed 0.5 meters and the height from the ground should not exceed 4 meters . If it goes beyond the scope, it will be considered illegal.
The installation method of the roof rack is as follows:
1. Attach the roof rack to the longitudinal rail, and when all four legs are completely loosened, remove both sets of crossmembers. bars. Place it on the longitudinal rail, adjust the span of the frame legs and the distance between the two poles, so that the lengths of the left and right ends of each aluminum pole are symmetrical, as well as the center distance between the hasfront and rear. the posts are not less than 700 mm. It's best to use a tape measure to adjust this step several times. Asymmetry or tilt will increase wind noise
2. is not less than 700mm, the frame can be tightened. Once the position of the feet is determined, two people are required to tighten the ends of the rod simultaneously from both ends.
3. A moment, then tighten it clockwise. The grip of the bracket feet will become tighter and tighter, and at the same time, the grip of the bracket feet and the aluminum rod will become tighter and tighter, maintain the position of the frame feet. during the tightening process and pay attention to the symmetry of the two ends, because once tightened, the left and right positions of the silver rod are difficult to adjust. How much tightness is appropriate? The easiest way is to simply usereading your wrist strength to twist it;
4. Install the lock cylinder and use a wrench or small screwdriver to remove the round lock cover on the plastic. Crank. Remove it, insert the key into the lock cylinder, push the lock cylinder into the hole and turn it clockwise to secure it. The crank and plug should not be able to be removed from the rod end after locking. Once the four ballast cores are installed and locked, the entire roof rack is installed and cannot be dismantled without a key
5. Once installation is complete, items should be inspected: visually inspect or measure with; a tape measure Check whether the position and span of the roof rack are symmetrical from left to right; hold the end of the roof rack crossbar and push and pull it in all directionss to see if there is play, check if the rocker and lock; The cores are locked in place and can be locked.
(Images/Text/Photos: Pacific Automotive Network Calling Beasts Q&A)
It is not illegal, but generally has no practical value . The car itself has an energy storage system that also provides direct current. When installing solar panels on the car roof, it is best to install aluminum plates, which can be tightly attached to the car roof, so that there is no burden or risk .
The rooftop solar cell is a semiconductor optoelectronic device that uses sunlight to directly generate electricity. On September 24, 2009, Yingli Photovoltaic Application Technology Research Institute of "China Power Valley" successfully developed the first cellsolar power in the world for car roofs. It is the world's first commercial photovoltaic module for car roofs. Automotive electrical equipment, reducing engine power generation load and fuel consumption, and can also be used as a supplementary device for power sources.