1. First drain the water from the water heater.
2. Clean the water inlet glass tube.
3. Hold the glass tube firmly with both hands and twist it clockwise and counterclockwise to loosen the glass tube.
4. Once the glass tube is loose, insert a section of the glass tube into the bucket. Once the bottom end of the glass tube is out of the base, slowly remove it. Remove the glass tube from the bucket.
Should the water inlet be opened when using the solar water heater
The water inlet of the solar water heater is usually a pipe threaded stainless steel, with silicone clamped between the hose and the water tank socket. Rubber seal, waterproof. The rubber sealing ring is elastic, and the pipe inserted inside can of course rotate as long as the sealing ring is not broken, there will be no leakage. Brief, it's okay if you turn it a little, but you can't turn it all the time. If it breaks, it will be embarrassing.
There are two holes at the bottom of the solar water heater barrel. One is filled with water. What is the other one for? After filling it with water, the water overflowed from the other hole.
Hello, it depends on the solar model you have. Typically, individual warehouses are filled with water via a solenoid valve installed on it. the water inlet pipe. On the road, if the set water shortage position is not reached, the solenoid valve is closed, and there is no water supply! But there is also a manual water supply. If you are using a solar water heater, do not turn on the water supply to let water in, as this will mix the hot water!
Recommended "Dr. Sun" solar energy, three warehouse models (no need for water level probes and solenoid valves), heating utilization rates andhot water are fast in rainy weather, and the after-sales service rate is also greatly reduced, saving time. It also saves electricity. This model only takes 20-30 minutes to heat without sunlight, while a single warehouse takes 2-3 hours! strong >I don't know if the hole you mentioned next to the water inlet is on the water tank. If it is the overflow hole, it means the water tank is full and the water is overflowing. from the overflow hole. The water supply valve must be closed.
Solar water tanks generally have six or five holes. The water tank is usually cylindrical, with two holes on each side. cylinder, usually divided into upper and lower holes. If one side is used, the upper hole is the water inlet hole, the lower hole is the water outlet hole, the lower hole on the other side is blocked, the hole supper is the overflow. The bottom hole on one side is the water inlet hole; the bottom hole on the other side is the water outlet hole.
There are two holes on the surface. of the cylinder. After the water tank is installed, there is a hole at the bottom of about 50mm for the electric heater hole, and there is another hole on the upper side of the water tank with a diameter of approximately 20mm. , this is the evacuation hole. You said "there are three holes in the solar water tank, and there is one hole in addition to the water inlet and outlet holes. For example, there is a drain hole on the upper side of the water tank." water tank, and there is an electric heating hole on the lower side.
Solar water heater is a heating device that converts solar energy into thermal energy, heating water from low temperature to high temperature to meet people's use. hot water in life and production. Salton the structure of solar water heater.The forms are divided into vacuum tube solar water heaters and flat panel solar water heaters. Evacuated tube solar water heaters are mainly used, accounting for 95% of the domestic market share.
Home evacuated tube solar water heaters are composed of heat collecting tubes, water storage tanks, brackets and other related parts. The conversion of solar energy into thermal energy mainly relies on vacuum tubes which use the principle that hot water is used. floats and cold water sinks, causing microcirculation of water to obtain the required hot water.