How to install a solar water heater booster pump

The steps to install a solar water heater booster pump are as follows: 1. Determine the location of the booster pump: The booster pump should be installed on the outlet pipe of the solar water heater, usually on the top or side of the water heater. 2. Prepare installation tools: You need to prepare wrenches, screwdrivers, tape and other tools. 3. Turn off the water source: Before installing the booster pump, you must turn off the water source to prevent excessive water flow from causing installation difficulties or burst water pipes. water. 4. Install the booster pump: install the booster pump on the outlet pipe of the solar water heater according to the instructions and secure it with screws. 5. Connect the power supply: Connect the power cord of the booster pump to the power outlet and make sure the power cord is ingood contact. 6. Test the booster pump: Turn on the water source and check if the booster pump is working normally. If there is any abnormality, it should be adjusted or replaced in time. 7. Complete the installation: After the installation is completed, you should check whether all the pipe connections are firm to ensure the normal operation of the booster pump. It should be noted that before installing the booster pump, you should understand the outlet water pressure of the solar water heater and the load capacity of the booster pump to ensure the safe use of the booster pump. overpressure. At the same time, the installation location and pipeline connections of the booster pump should also be operated in accordance with the requirements of the instructions to avoid water leakage or other safety issues.