1. First, make sure the pipe insulation is tight enough and the heating tape is long enough and easy to use. Normally, hot water will come out about 5 minutes after turning on “pipe insulation”;
2. If the weather is too cold and the water in the pipe freezes, install it. the antifreeze belt and turn it on first. Use antifreeze tape to melt the pipes, then turn on the pipe insulation
3. It is best to install a pipeline drain; device. If the pipeline is empty, there will be no cold water. Turning on the solar water heater results in a large amount of cold water and once the pipes are drained, they will not freeze in extremely cold weather.
4. It is best to heat the solar heating belt for 5 to. Heating it intermittently for 10 minutes can extend its life. If used for a long timeIf there is no power supply, it will generally have to be. replaced in less than two years.
The shielded electric heating tape with a layer of metal shielding mesh can be connected to the ground wire through a special electric heating tape junction box, which can prevent the sparking phenomenon at the the common part and play a role in earthing. protection. This standard electric heating tape is suitable for pipe insulation applications in flammable and explosive locations.
The metal shielding net has an excellent protective effect on the middle strip of the electric heating tape, which makes the electric heating tape very durable. Pipe insulation suitable for special occasions can prevent the inner band of the electric heating tape from being separated from the metal wires, resulting in no heat.