36mm. According to the relevant information from Linorite Solar, we learned that the diameter of the water outlet is generally 36mm. Each manufacturer is slightly different. The vacuum tube hole is 63. Both fixed modes rely on silicone ring extrusion sealing. The water inlet pipe of the solar water heater is generally 16mm in diameter. Commonly known as 4-point tubing, it is sufficient for general domestic use, but wider specifications are required for commercial use. The diameter of the water tank drain outlet of common household solar water heater is 20 or 25 pipes with thread.
Leaks in solar sewer pipes are usually caused by a leak in the inner tank or the aging of the outlet pipe joint. If the inner tank leaks, you should seek professional after-sales service. staff to take care of it.
If the water outlet pipe sealing ring is getting old, you can find a piece of wire or cotton thread and carefully wrap it around the leak area, then roll it up carefully after wrapping it. , use 502 glue to soak all the coils, just wait for the glue to dry.
Treatment methods:
1. Close the indoor water line valve and stop the water supply. Then use a wrench to remove the gasket at the leak point to see if the gasket's pipe connections are damaged. If it is damaged, simply replace it with a new one.
2. If there is no damage, you need to check whether the sewer pipe head is flat, smooth it, and then connect the joints. Pay attention to gaskets that must be installed tightly to prevent leaks. once again.
3. If inspection shows that there is a water leak between the pipe connections, you need to disassemble the pipe fittings, wrap the raw material tape around the threaded position, and then reconnect the pipe fittings. he.
4. If PVC pipes are used, the leaking parts must be cut out, then the new PVC pipes must be installed with glue. And if there is water leakage at the joint, it should be wrapped with raw material tape and put back in place.