Tools needed: board, pliers, screwdriver.
1. First use pliers to remove all power cords from outside of the water heater's heating rod.
2. Then unplug the connection wires around the water heater one by one.
3. Then use a screwdriver to remove the surrounding small screws.
4. Then use a wrench to unscrew the surrounding large screws.
5. After that, you can remove the outer fixed cover.
6. Then you can remove the heating rod from the water heater.
Detailed information:
Thawing refers to the electric heating belt (also called anti-freeze belt), the choice of this heating belt is also very critical if the connection of the heating belt is. not good, it will cause electricity to be connected and burn the pipe insulation. This has happened several times in the market. It is also necessary to choose hot melt adhesive sealing technology and conductive copper core. the material should not be less than 0.2mm. Any thickness less than this value does not comply with the standards.
Tubes 4 and 20 are inserted into the tube75.
The numbers on the heating rod are divided into two types: roof and interior. The roof will display De20, which is a temperature tube separated by 20 degrees. When indoors, it will display De20, which is a temperature tube separated by 20 degrees. display De75. This 75 refers to the 4 and 20 temperature tubes interspersed with the 75 degree tube.
After the solar water heater is filled with water, it generally takes a day to heat in winter and half a day in summer. Hot water is heated and stored in the water tank. It can generally be stored for 48 to 72 hours. The water tank is well insulated, unless you have an old-fashioned solar system with no insulation or poor insulation.