Installation Method of Split Solar Water Heater:
Installation of Split Solar Water Heater
Wall Strength: This water heater should be installed on a solid wall , and the strength of the wall can withstand The water heater weighs 4 times its total weight after being filled with water, without deformation or cracking. If it cannot withstand it, special supports must be installed or reinforcement measures taken.
Drilling: Use an impact drill to drill 2 holes horizontally on the solid wall according to the installation dimensions. The depth of the hole is 100mm. The hole spacing is as shown in the figure above between the two brackets. overall dimensions of the fuselage distance.
Installation: Insert the expansion bolt into the hole, tighten the hook and hold the hook up. Align the bracket above the water heater with the expansion bolt hook and hang-it securely. Install a power outlet on the wall. The requirements for the power outlet are: 250 V/10 A three-pole, single-phase. It is recommended that the power outlet location be on the upper right side of the water heater. In places and walls where water may splash, the installation height of the power socket should not be less than 1.8 meters, and ensure that water does not splash on the socket. Do not install it where children can reach it.
Near water source: If the bathroom space is small, the indoor unit can be installed in another place protected from sun and rain. In order to avoid heat loss in the pipes, the installation point must be as close as possible to the water point. After the installation of the fuselage is completed, set the rotary temperature adjustment knob to “0” in sunny weather; in continuous rain, when activatedelectric assistance: set the rotary temperature adjustment knob to the temperature to be set, and turn it clockwise to increase the temperature, and counterclockwise to increase the temperature. The clock hand rotates to reduce the temperature, and it can usually operate at the highest temperature position.
Pipeline link of indoor unit of split solar water heater
Safety valve: A one-way safety valve should be installed at the cold water inlet of the 'unit. Connecting the one-way safety valve: Install the one-way safety valve supplied with the machine to the water inlet of the main unit.
Thread Note: The thread specifications of all pipe fittings are G1/2″. To prevent water leaks when connecting the pipes, a sealing washerRubber insert should be installed on the end face of the thread. pressure relief pipe On the pressure relief hole of the one-way safety valve
Is the solar water heater dual-use?
I found it to be inappropriate It There was this ad on TV. , but the actual effect is questionable. First, the space available for the water heater to install the panels is too small and the power generated by the small solar panels is too low. Second, batteries alone are not enough. inverters are also needed to store and convert them into mains electricity. Finally, there is the price. It is expensive, this set is not cheap, and its lifespan is no more than ten years.
My opinion is that. you should not easily believe what is happening on television.
Is dual-use photoelectric solar energy necessary?
Solar water heaters currently knownr the market
.are both photoelectric and photovoltaic, but solar water heaters are best used in summer and winter.
The solar water tank
It. is on the roof and is so big. It is not easy to heat water with such electrical resistance, even if the water is hot.
Water pipe
I'm afraid it will freezes too.
It's necessary. Dual-use solar photovoltaic is a technology that uses solar energy to produce electricity and lighting. It combines photovoltaic energy production and the use of solar thermal and can directly convert solar energy into electrical energy for heating, hot water, etc. This can make full use of solar energy resources, improve energy efficiency and protect the environment. Dual-use photovoltaic solar energy is therefore necessary.