The method of adding water to this product is as follows:
Tools: Muyang Solar Energy.
1. Open the water inlet valve and outlet valve of the solar water heater.
2. Check if there is enough water in the water tank. If it is insufficient, it must be filled in time.
3. Wait a few minutes to allow the water in the water tank to circulate completely.
4. Close the water inlet valve and the water outlet valve, and the solar water heater will automatically fill the water.
It should be noted that when filling the water, you should ensure that there is enough water in the water tank, and the filling time should not be too long long to prevent the water temperature in the water tank from being too high. At the same time, when using solar water heaters, you should pay attention to safety and avoid burns.
How to use the heaterMuyang solar water
1. After pressing the setting button for three seconds, the temperature number that needs to be set will flash.
2. Continuously press the setting button until the temperature is a few degrees lower than the desired set temperature.
3. Continue to press the increase button until the desired temperature is lower than the current temperature. Once the setting is complete, press the setting button to save the current temperature setting.
1. After installing the solar water heater, first turn on the device and check if it is working properly. Press the leak switch button. The power light will turn red, indicating that heating has started. When the heater reaches the set temperature, press the leakage switch button, the power is turned off, the indicator light goes out, and the heater stops.
2. Once the water is heated, it cannot be used immediately. The heating power should be turned off first to avoid leaks during bathing.