The installation method of solar photovoltaic racks can be divided into the following steps:
①. Determine the installation location: First, you need to determine the installation location of the solar PV racks, usually on a flat roof or on the ground. Make sure the installation location can receive full sunlight and is free of obstructions.
②.Prepare supporting materials: According to the design requirements and installation location, prepare the required supporting materials, including supporting frames, supporting columns, connectors, etc.
③. Install the support column: According to the design requirements, fix the support column at the installation position, which can be fixed with bolts or concrete foundation. Make sure the support posts are plumb and stable.
Case study of photovoltaic support for tKesheng color steel tile roof
④ Install the support frame: Connect the support frame to the support column and use bolts or other connectors to fix it. Make sure the support frame is flat and stable.
⑤. Install photovoltaic panels: Install the photovoltaic panels on the support frame and fix them with clamps or screws according to the design requirements. Make sure the photovoltaic panels are installed flat and stable.
⑥. Connect the cable: Connect the cable from the PV panel to the inverter or battery, making sure the cable connection is firm and secure.
⑦. Testing and debugging: After completing the installation, carry out testing and debugging to ensure that the photovoltaic system operates normally.
It should be noted that the installation of photovoltaic solar racks requires technical design and installation.professional matters. It is recommended to hire a professional installation team for operation. At the same time, pay attention to safety during installation and follow proper safety procedures.
Push the solar tube up to separate the bottom from the base, then pull it down to remove it. Be careful not to damage the lower part like a small column of glass in a thermos. bottle, otherwise it will not work isolated. Remove the silicone ring and replace it, press it in the opposite direction and you will be fine. When installing, apply a little soapy water to the glass column, it will be more convenient.