1. The water mixer, pipeline and safety valve may be blocked, resulting in large-scale leakage.
2. It is also possible that it has been used for a long time and has cracked. For example, the seal has aged and cannot achieve the sealing effect, which will also cause water leakage.
3. Another reason is that if the inner tank of the water heater ruptures due to temperature difference, the overflow port will also leak slowly if it is caused by the mixing valve or pipeline. including safety valve. If such an accessory fails, you can directly replace the affected accessory to solve the problem.
Precautions for using solar water heaters
The water stored in the solar water heater should be drained regularly to avoid water accumulation and long-term pollution term. The cycle of rejectionis determined by local water quality conditions. The rejection can be carried out in the morning because the sensor temperature is lower there.
Turn on the cold water first, then the hot water: if the weather is sunny for several consecutive days without using hot water, the water temperature will be relatively high. You need to turn on the cold water first, then the hot water. to avoid this burn.
For the above contents, please refer to Baidu Encyclopedia - Solar Water Heater, Baidu Encyclopedia - Overflow Pipe, People's Daily Online - Water Heaters water require regular bathing.
What are common causes of solar water heater leaks? How to repair?
Solar energy is still a commonly used type of water heater in homes in many counties. In good weather, the water in the solar energy will be heated by the heat of the sun, which is very convenient for taking a bath. However, the solar power needs to be filled with water in advance, so what happens if the water-filled solar power leaks?
What's wrong with solar water leak?1. The vacuum tube is leaking. First of all, you can't use vacuum tubes if it's winter because they will freeze if it's summer. There is no need to worry about the vacuum tube freezing, but avoid watering at noon and try to use it in the morning or evening. Because it is hot at noon, the temperature inside the vacuum tube will also increase if the water is cold. injected at this time, the vacuum tube will not be able to support it, and the vacuum tube will eventually rupture, causing solar water leakage.
2. The silicone ring is broken. If the vacuum tube does not leak, it means that the problem is not with the vacuum tube, so everyone should pay attention to other places. If the water tank and vacuum tube leak from the holes, or the bucket lid leakst, the silicone ring is broken.
What to do if the mouth of the solar glass pipe is leaking.1. Water pipe connections and joints are leaking. It depends on the type of pipeline used. For hot melt pipes, water leaks usually result from poor connection during hot melting; For aluminum-plastic pipes, the screws are usually not tightened or the sealing rings are damaged.
2. There is a water leak at the connection between the joint and the water tank pipe. This is often caused by the raw material belt not being properly wrapped.
3. There is a water leak at the connection between the water tank pipe and the water tank. There are two commonly used connection methods: welding and silicone sealing. If it is a welded type, the water tank will need to be replaced. If the warranty period exceeds the warranty periodantie, you need to find an argon arc welding master to open the insulating layer and weld it properly. If it is a silicone seal ring, just replace the seal ring. If it cannot be replaced, you can replace the upper exhaust port sealing ring as a spare part.
Solar solutions for water leakage1. Vacuum tube leaking: Close the faucet first. If it is automatic, turn off the power first, then drain the water from the bucket, then remove the broken vacuum tube. If it cannot be removed, you can apply a little lubricant on the vacuum tube, then tilt the water tank to remove the vacuum tube, then go to the store to buy a vacuum tube and install.
2. The silicone ring is broken: As the silicone ring is inside, you need to remove the vacuum tube first, then touch the silicone ring into the bucket to see ifhe fell. If it falls, remove it. If it falls off, remove it, remove it again, clean the surrounding insulating material, then replace the silicone ring and reinstall the removed vacuum tube.
Solar water heater side hole leak
The common causes and repair methods of solar water heater leaks are:
1. Inner tank weld seam cracked, solution is to replace the water tank or weld the open area. ?
2. The sealing ring is damaged. In this case, simply replace the sealing ring. ?
3. Improper installation of the water tank will also cause water leakage in the solar water heater. ?
4. The vacuum collector tube is broken If this happens, you need to have a professional installer come and install it. ?
5. The temperature of the cover plate is too high and the pipe installation position needs to be adjusted.
Daily maintenance:
1. When installing a solar water heater, there may be a smell of dust or oil in the water pipe when using it. the first time you can turn on the faucet to remove it first.
2. The water stored in the solar water heater should be discharged regularly depending on local water quality conditions. Drain time can be selected in the morning when the sensor temperature is lower.
3. The surface of the solar water heater should be wiped regularly depending on the amount of dust in the area. It can be cleaned when it rains. Keeping the water heater surface clean can get higher heat. collection efficiency.
4. When hot water is not used for several consecutive sunny days, the hot water temperature will be very high. When using the solar water heater, please firstturn on the cold water, then the cold water. hot water to avoid burns.
5. There is usually a filter device at the outlet end of the faucet. Scale and debris in the water line accumulate on this screen. It should be removed and cleaned regularly to increase water flow. smooth the flow.
6. It is very common for pipes to be frozen in the winter. If the pipe is found to have frozen but not yet cracked, it can usually be cleared automatically after the temperature rises. You can also use a hair dryer to blow on the water line, or wrap a towel around the water line and then slowly pour warm water over it. Do not cook it on fire, hit the water pipe, or scald it with boiling water, because. this will cause the pipe to burst. Multiple freeze blockages can easily cause pipes to freeze and crack.Pipe insulation measures must therefore be reinforced.
7. Solar water heaters are needed every two to three years on average. Perform cleaning, inspection and disinfection. Users can also carry out some disinfection work themselves. For example, they can buy a disinfectant containing chlorine and pour it into the water inlet, let it soak for a while, then release it. it, which can achieve a certain level of disinfection and sterilization effect.
8. Solar water heaters need to be cleaned inside the vacuum tube every two to three years on average to prevent scale from forming inside the vacuum tube and affecting the heat absorption effect.
9. If the solar water heater is equipped with special instruments, please pay attention to lightning and electricity protection. Do not take a shower and unplug the heating plugelectrical during lightning.
The main reasons for leaks from the side hole of the solar water heater include excessive tap water pressure, too long return pipes and valves. blocked water supply, etc. Before repairing the leak problem, you must turn off the power to the water heater and stop using it to avoid further dangers. The specific reasons will be presented in detail below.
1. Since the tap water pressure is too high, it will splash during the filling process, causing water to flow out of the water tank from the side hole before it is full. This phenomenon The general solution is to adjust the tap water pressure to the standard water pressure.
2. The leakage from the side hole of the solar water heater may also be caused by the return pipe being too long or not smooth enough, which prevents the water from flowing out of the return pipe in time.the water is full. The actual water in the water tank is full, and water continues to flow out from other side holes.
3. If the side hole of the solar water heater is leaking, it is likely that the water supply valve or solenoid valve is not closed tightly, causing the water to always flood when the water is full. will flow out of the side hole. The solution is to turn off the water supply valve or repair the faulty parts.