The correct steps to replace the solar water heater probe: First, slowly rotate the old probe out of the solar barrel, then cut off the old probe. When cutting, keep the wire longer, about 30 centimeters. Dial the wires, then connect each wire of the new probe with the same color as the original cut wires, then slowly put it back into the bucket, then fill it with water to see if it can reach 100%. It is not enough to remove the probe a little, but to lower it a little.
Clean once a year.
1. Tools/Materials
Solar energy and water.
2. Methods/steps
1. Carefully remove the dust seal ring on top of the header tube.
2. Remove the black collection tube.
3. Pour the water into the collection tube and pour out the scale at the same time.
4. Remove the rubber sealing ring inside the water tank mouth.
5.Remove large pieces of tartar.
6. Then rinse the scale from the water tank with plenty of water.
7. Install the rubber seal ring.
8. Install the collector tube.
9. Press the dust ring.