The operation steps are as follows:
Push the solar tube up to separate the bottom part from the base, then pull it down to remove it. Be careful not to drop the bottom part. The piece looks like a small glass solar tube in a thermos bottle. If the silicone ring column is damaged, it will no longer be insulated. Remove the silicone ring and replace it, press it in the opposite direction and you will be fine. When installing, apply a little soapy water to the glass column, which is more convenient.
Detailed information:
1. When installing the solar water heater, there may be a smell of dust or oil in the water pipe. When using it for the first time, you can open the tap to. remove the debris first.
2.The water stored in the solar water heater should be discharged regularly depending on local water quality conditions. Drain time can be selected in the morning when the sensor temperature is lower.
3. The surface of the solar water heater should be wiped regularly depending on the amount of dust in the area. It can be cleaned when it rains. Keeping the water heater surface clean can get higher heat. collection efficiency.
4. When hot water is not used for several consecutive sunny days, the hot water temperature will be very high. When using the solar water heater, please turn on the cold water first, then turn on the cold water. hot water to avoid burns.
5. There is usually a filter device at the outlet end of the faucet. Scale and debris in the water line accumulate on this screen. It must be removed and cleaned regularlyt to increase the water flow. smooth the flow.
6. In winter, it is very common for pipes to freeze. If it turns out that the pipe has frozen but is not yet cracked, it can usually be cleaned automatically after the temperature rises. You can also use a hair dryer to blow on the water line, or wrap a towel around the water line and then slowly pour warm water over it. Do not cook it on fire, hit the water pipe, or scald it with boiling water, because. this will cause the pipe to burst. Multiple freeze blockages can easily cause pipes to freeze and crack. Pipe insulation measures must therefore be reinforced.
7. Solar water heaters should be cleaned, inspected and disinfected on average every two to three years. Users can also carry out some disinfection work themselves. For example,they can buy disinfectants containing chlorine. and add them to the water. Pour it into your mouth, soak it for a while, and then release it, which can achieve a certain disinfectant effect.
8. Solar water heaters need to be cleaned inside the vacuum tube every two to three years on average to prevent scale from forming inside the vacuum tube and affecting the heat absorption effect.
9. If the solar water heater is equipped with special instruments, please pay attention to lightning and electricity protection. Do not take a shower and unplug the electric heater during lightning.
Baidu Encyclopedia: Solar Water Heater
The sealing ring of the solar water heater cannot be replaced. The sealing ring of the solar water heater is the gasket. installed on the pump and motor shaft. Prevent external dust and rainwater from enteringthe sealing mechanism. Replacing it will cause deterioration of the seal ring and reduce its durability, so it cannot be replaced or removed.
Detailed information:
Other functions of the seal ring:
The end cover gasket prevents hydraulic oil from leaking from the end cover gap. and the cylinder tube. The surface is under pressure, which requires strong anti-extrusion ability and good sealing effect. The piston gasket is bidirectionally pressurized to prevent hydraulic oil from leaking between the piston and piston rod, which requires. strong anti-extrusion ability and good sealing effect.
1. Clean the installation position;
2. Remove burrs during the joint installation movement;
3. p>
4. Protect the sealing surface from damage;
5.Check and confirm that the gasket size is correct
6. requires tool deformation and installation.
Sealing ring from Baidu Encyclopedia