Plugs are easy to burn due to poor contact, especially for high-power electrical appliances. You can replace the plugs and sockets yourself. The premise is that two problems need to be resolved. The first is that the connection is good. and the other is that the insulation is restored and wrapped well< /p>
The plug can be cut from the plug and the cord with pliers, peel off the insulation from the cord (about 5 cm is enough) and connect directly with a good quality plug. The cord has three wires, and the yellow and green ones are for the ground wire, connected to the top terminal of the plug, the red wire is connected to the right side of the plug, usually connected. to the live wire (to ensure that the live wire is connected to the socket), and the other blue wire is connected to the neutral wire if the original wire is not long enough, you can buy the same wire ; and plug it back in. The connector must be connected tightly and wrapped with insulating tape.
It is better to buy the type of socket that does not have a switch button (due to the high power, the switch is easy to burn out ) ), you need to unplug the main circuit breaker when replacing the socket (to avoid electric shock when replacing, be careful, it is very dangerous), you can use a flat blade screwdriver to pry the socket shell along the outer edge of the homing socket. After loosening the fixing screws, you can remove the plug. Remember to connect the new wire from the plug to the back of the plug box as is. /p>
The replacement steps are roughly like this. It is very simple. Buy it yourself. You should buy good electricity when you use it, otherwise it will burn out again after a short period of time.
About the water heater leak protection capsolar
Plug it in when you need to use it, and when you don't need it, plug it in. Not used sometimes.
The solar water heater is a heating device that converts solar energy into thermal energy, heating water from low temperature to high temperature to meet the use of hot water by people in life and production. Solar water heaters are divided into vacuum tube solar water heaters and flat panel solar water heaters based on their structural shapes. Evacuated tube solar water heaters are mainly used, accounting for 95% of the domestic market share. Household evacuated tube solar water heaters are composed of heat collecting tubes, water storage tanks, brackets and other related parts. The conversion of solar energy into thermal energy mainly relies on vacuum heat collecting tubes which use theprinciple of hot water floating. and cold water flows to cause microcirculation in the water. Get the hot water you need.
Is it safe to unplug the solar water heater when taking a bath?
The leakage protection plug of the solar water heater is a specially designed electrical outlet used to prevent leaks, including plugs with the same function for electric water heaters. , this socket must be installed when installing a solar water heater. Of course, other sockets can also be installed to heat normally, I recommend using a leakage protection socket. are: the top one is connected to the ground wire, the left side (L) below is the live wire, and the right side (N) is the neutral wire. Please check if your socket is configured like this. THANKS !
It is absolutely safe to unplug it. Generally, the heater plugffe-water is the live wire. The neutral wire and ground wire are equipped with leakage protection function.
Solar water heaters mainly depend on the sun. Generally, good quality solar water does not require electric heating. You can simply unplug the plug if there is no sunshine for a long time and you want to take one. bath, you can plug in the socket. Use an electric space heater, unplug it after heating.
I hope this helps you.