This so-called wind power plant is actually the “big windmill” that everyone knows. A motor is installed in the windmill. When the desert wind blows, it pushes the blades of the wind power plant (so these blades must be both light and strong) to spin, providing heat to the engine and then converting the heat. This is the whole process of producing wind energy. But the construction of this wind power plant also requires certain skills. The windmill blades cannot be too heavy, otherwise the wind may not be able to push the windmill. At the same time, the blades must be very strong, otherwise the sand will mix. with the wind in the desert, it will definitely break the leaves. At the same time, the part below the wind power plant must also be very strong, because we all know that the power of sandstorms is very huge. If the wind power plant is notIf it is not well constructed, it risks being blown away by the wind. Sandstorm.
Therefore, we must not only discover energy, but also protect it and create a magnificent “global village” with our hands!
I want to use the motor from the hair dryer to make a 20 volt generator. How should I do this?
1. First, you need to determine the positive and negative. poles of the small battery to be connected. The positive terminal of the battery is raised, while the negative terminal is flat.
2. Next, you need to find the positive and negative poles of Mr. Fu's fan motor. They are found on the generator wires. A wire is connected to the positive terminal of the motor. the other wire connects to the negative terminal of the motor.
3. Finally, use a wire or other suitable connector to connect the positive terminal of the battery to the positive terminal of the generator, and connect the negative terminal of the batteryi.e. to the negative terminal of the generator, making sure the connection is firm to avoid power interruption or short circuit.
If you use it as a charger, please connect a diode in series to one end of the output line. If you use it as lighting, it only needs a drive motor to rotate.
Tap water can be used as a driving method. Manual wind of the bicycle, etc. I suggest you always use tap water. Just pull the small tap water hole into the fan blade if you manage to buy heat capacity glue. and make a box to surround the water flow, it will be perfect