This should be possible. I suggest you take it to an appliance repairman to see if it can usually be repaired.
If it's not expensive, repair it.
If it can't be repaired, it's basically cheap to buy a new one
I hope you can adopt it
As an electrician , who can fix the little sun?
The solar water heater is a device that uses solar energy to convert thermal energy into hot water. It may inevitably malfunction during use. So can solar water heater be repaired?
The answer is yes. There will be some problems when using solar water heaters, such as water leakage, insufficient water temperature, etc. These problems can be resolved by repair. It should be noted that since the solar water heater is a complex device, it is recommended to seek help from an engineer.professional for certain more complex defects.
Here are common faults of solar water heaters and how to fix them:
1. Water leak
If the solar water heater is leaking, you need it. First determine the location of the leak and then remedy it. Most leaks are caused by poorly connected or poorly sealed joints. You can check the gaskets by disassembling, adjusting, and reinstalling them to ensure a good seal.
2. The water temperature is not enough
If you find that the water temperature of the solar water heater is not enough, there may be many reasons, such as an insufficient heat collection area. solar water heater, or the water heater pipe is blocked, you can increase the heat collection area or clean the pipes to solve the problem.
3. Water pollution
Since impurities and wastes easily accumulatent inside the solar water heater, causing water pollution, this problem can be solved by cleaning the water tank or replacing the filter.
In short, the breakdown of solar water heaters can be solved by repair, but it should be noted that to ensure safety and efficiency, seek help from professional engineers and do not Never carry out repairs yourself. At the same time, during daily use, attention should also be paid to the regular maintenance of solar water heaters to ensure their normal operation.
How to fix broken solar timer
1. You can use the resistance setting of a multimeter to check if Little Sun's power switch is good and turn it on and off!
2. If there is no problem with the switch, check the position of the power cord (live wire and neutral wire). Don't just use aelectric pen to turn on the live wire. If the neutral wire is broken, the neon tube of the electric pen will light up. also lights up when measuring with an electric pen!
3. If there is no problem, check to see if one of the Little Sun's reversing switches is broken. In other words, when the Little Sun is placed upside down, the reversing switch is disconnected, which is for protection! If the reversing switch is broken, you can directly connect the input and output wires of the reversing switch without reversing the switch!
4. Personally, I think one of your power cords (two wires) is broken! You can try changing the power cord.
The equipment is aging and damaged.
1. First, do not wind the spring, loosen the splint clamp, gently spread the upper and lower splints, use tweezers to remove the balancer to respring and the pallet fork, then press the splint firmly. screw in the spring and let the gear set spin quickly for a while, then spray and clean the plywood and gear set with rust remover. Since the anti-rust product itself has strong decontamination ability and a certain degree of lubricity, it can be cleaned with it, dried or blown, and then restored.
2. Second, if you can't buy rust remover, you can also use a small oil brush dipped in gasoline or alcohol to scrub. After drying, add a little sewing machine oil or watchmaker oil to the plywood shaft hole and pallet fork pin. There is no need to add oil to the gear to prevent damping.
3. Finally, if there is no gasoline or alcohol, you can also use toilet water to clean. A timere cleaned with eau de toilette also works well and will leave a fragrant scent.