1. First, remove the silicone ring from the warped water heater, boil a pot of water as quickly as possible and pour it into the container.
2. Then pour the boiling water into the container and place the silicone ring of the water heater into the boiling water.
3. After soaking for a few minutes, remove the silicone ring and pull it out with your hands. The silicone ring of the solar water heater can be restored.
Causes: 1. Usually the solar seal ring is damaged. In this case, you just need to replace a few silicone solar rings. It is very likely that the silicone ring imported from Solar Energy is cracked. You can remove the old silicone ring and replace it with a new one. 2. If the solar water heater leaks at the sealing ring, it is usually because the sealing ring between the vacuum tube and the water tank is damaged and can be replaced. The rThe water tank has not been cleaned for a long time and the scale has corroded the inner tank, causing water leaks. However, it is very difficult to repair the inner tank. Suggested treatment methods: 1. Pay attention to purchasing the same type of silicone ring and do not buy a size that is too large or too small. If you install it this way it will always only leak when a silicone ring matches. The size is installed, can the leakage from solar inlet be stopped. In addition, the silicone ring should not be installed upside down during installation. If installed upside down, the problem will not be resolved. 2. The seal ring leakage may be caused by the aging of the seal ring. Simply replace a seal ring. First, drain the water, remove the electric heater and remove the silicone ring. 3. The only solution is to replace the inner tank. In functionOn water quality, solar cleaning every two to three years is necessary.