Balcony solar power generally adopts a wall-mounted installation method, that is, the solar power is hung on the balcony, so that the existing balcony structure is not damaged when installing. installation and the overall beauty of the balcony is affected. If all residents in the city install solar energy in this way, the overall beauty of urban buildings will not be affected by the disorderly installation of solar energy in the city, and safety accidents caused by solar problems. The installation of solar energy will also be reduced.
When installing solar energy on a balcony, you should choose the sunny side of the balcony, in order to maximize the use of solar energy and ensure sufficient solar energy. The strong wind on the balcony will cause greater damage to the solar components, so the components of the balcony solar should be made frommaterials meeting higher quality standards, so that the lifespan of the balcony solar is not reduced.
Content of this article comes from: "Bathroom, Corridor, Hall, Stairs" by Construction Industry Press
What are the precautions to take when installing wall-mounted solar on a balcony?
1 First of all, it is necessary to respect the lighting duration of the user's home before installation, which should generally not be less than 4 hours. Less than 4 hours will affect daily water consumption.
2 The bracket is generally made of hot-dip galvanized angle iron and equipped with 304 stainless steel screws. When installing the bracket, be sure to pay attention to the end of exit from. the collector being 3 to 5 cm higher than the tail, which is too high. Height will affect appearance. Once support is installed, it should not affect users at the bottomto avoid problems in the future.
The solar water tank should look good when installed, because users will see it every day. There is also room for after-sales personnel to carry out repairs.
3 The most important thing to mention is the installation of the fluid circulation pipe. The length of the first pipe should not exceed 3 meters and there should be no gaps in between. second pipes. In the case of dead turns and inverted slopes, in nature, heat rises and cold falls. If both of these situations occur, it is likely that the water is not hot now.
4 Finally, I would like to point out that you should pay attention to your own safety and the safety of people below during installation.
1. The height of the water tank is greater than that of the collector, and the vertical distance is not less than 30cm. 2. Check if theThe water outlet direction of the collector is on the side of the water tank. 3. The upper and lower positions of the bracket are not based on blocking the windows at the bottom. The left and right positions are 50 cm from the edge of the collector. 4. Perforation of the collector circuit and water tank: If the water tank is installed on a balcony or indoors, it is generally necessary to open a hole with a diameter of at least 65 mm above the inlet and outlet of the heat recovery module. Pay attention that the hole in the wall is higher on the inside and lower on the outside. 5. A floor drain should be reserved under the water tank. 6. An overflow pipe should be installed on the safety valve of the water tank and should be connected to the floor drain.