1. First drain all the water from the solar power.
2. There is a silicone ring where each hose and the water tank are connected. Firstly, push the silicone ring down, you can remove it with a little force. about ten centimeters. There will then be no obstacles.
3. Push the tube towards the water tank, then the bottom of the tube will come out of the slot below.
4. At this time, simply go down and take out the hose from the water tank. The order when you go up is the reverse of the previous one.
5. Be careful not to break the small tip at the bottom of the solar tube. It has the same principle as the kettle bladder. It is best not to test the water at midday to avoid any breakage.
First hold the end of the glass tube near the insulation barrel with your hands, then slowly twist it. If it spins, crouch on the other end of the glass tube, which is there. end close to the ground, then reuseez it. Hold the hand with both hands and turn it slowly, then push it up while turning. Be careful not to break the bottom end of the glass tube, that is, the small tip of the glass tube. insulating tube at the end near the ground. Continue to twist and push upwards until the small tip can be removed from the shelf. Just when it is stuck in the air and can be lifted, be sure to hold the small tip with your. hands. This rotates by pulling down and then you can remove the tube. Repeat the steps above during installation.
The solar water heater is a heating device that converts solar energy into thermal energy, heating water from low temperature to high temperature to meet the use of hot water by people in life and production. Solar water heaters are divided into vacuum tube solar water heaters and solar water heatersflat screen based on their structural shapes. Evacuated tube solar water heaters are mainly used, accounting for 95% of the domestic market share. Household evacuated tube solar water heaters are composed of heat collecting tubes, water storage tanks, brackets and other related parts. The conversion of solar energy into thermal energy mainly relies on vacuum heat collecting tubes which use the principle of hot water floating. and cold water flows to cause microcirculation in the water. Get the hot water you need.
Reference materials: